Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Brake System Warning Lamp

Nissan Rogue (T33) 2021-Present Service Manual / Brakes :: Brake System / Dtc/circuit Diagnosis :: Brake System Warning Lamp

Component Function Check

CHECK BRAKE SYSTEM WARNING LAMP FUNCTION

Check that brake system warning lamp turns ON for several second after Ignition switch is turned ON.

Is the inspection result normal?

YES>>

Inspection End

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK ELECTRICALLY-DRIVEN INTELLIGENT BRAKE UNIT POWER SUPPLY AND GROUND CIRCUIT

Perform the trouble diagnosis for Electrically-driven Intelligent Brake Unit power supply and ground circuit. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair / replace harness, connector, terminal, fuse, or fusible link.

PERFORM SELF-DIAGNOSIS

CONSULT

Perform self-diagnosis for “BRAKE” and “ABS”.

Is a malfunction detected?

YES>>

Check the error-detected system.

  • “BRAKE”: Refer to DTC Index.

  • “ABS”: Refer to DTC Index.

NO>>

GO TO 3.

CHECK BRAKE SYSTEM WARNING LAMP ILLUMINATION

Check the Combination meter. Refer to On Board Diagnosis Function.

Is the inspection result normal?

YES>>

Replace the Electrically-driven Intelligent Brake Unit. Refer to ELECTRICALLY-DRIVEN INTELLIGENT BRAKE UNIT : Removal & Installation.

NO>>

Repair or replace Combination meter. Refer to Removal and Installation.

    Dtc/circuit Diagnosis. Brake Warning Lamp
    Component Function Check CHECK BRAKE WARNING LAMP FUNCTION (1) Check that brake warning lamp turns ON for several second after Ignition switch is turned ON. Is the inspection re...
    Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting
    NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference...

    Other materials:

    Cylinder Head
    Exploded View REMOVAL Cylinder head assembly Knock pin Cylinder head gasket Comply with the assembly procedure when tightening. Refer to Removal and Installation.         : N·m (kg-m, ft-lb) : Always replace after every disassembly. : ...

    Adp Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). Driver seat control unit Harness con ...

    B2720-05 Corner Sensor [rl]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2720-05 CORNER SENSOR [RL] (Corner sensor [rear left]) Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold Configuration of so ...