Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2908-31 Slide Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Body Interior :: Automatic Drive Positioner / Dtc/circuit Diagnosis :: B2908-31 Slide Sensor

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC detection condition
B2908-31 Slide Sensor Diagnosis condition When the ignition switch is ON.
Signal (terminal) Sliding Motor (terminal #3)
Threshold Sensor signal not received
Diagnosis delay time 100 mili- seconds or more

POSSIBLE CAUSE

  • LH sliding motor

  • Driver seat control unit

  • Harness and connectors

FAIL-SAFE

Stop automatic drive position function.

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON and wait for 20 seconds or more.

  2. Check “Self diagnosis result” mode of “DRIVER SEAT”.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK SLIDING MOTOR SENSOR SIGNAL

  1. Ignition switch OFF.

  2. Disconnect driver seat control unit and LH sliding motor.

  3. Check continuity between driver seat control unit harness connector and LH sliding motor harness connector.

Driver seat control unit LH sliding motor Continuity
Connector Terminal Connector Terminal
B213 35 B216 3 Yes

Is the inspection result normal?

YES>>

Connect driver seat control unit and LH sliding motor. Refer to Component Function Check.

NO>>

Repair the harness or connector.

    Dtc/circuit Diagnosis. B2908-12 Slide Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B2908-12 Slide Sensor Diagnosis condition When the ignition ...
    Dtc/circuit Diagnosis. B2909-11 Slope Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B2909-11 Slope Sensor Diagnosis condition The Thigh Support ...

    Other materials:

    C0513 Wheel Speed Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C0513 00 Right rear wheel speed sensor (Right Rear Wheel Speed Sensor Range/Performance) Diagnosis condition Ignition switch ON Battery voltage: 11 V ...

    Power Socket. Removal and Installation. Power Socket
    Power Socket Console Power Socket Removal and Installation REMOVALRemove switch panel. Refer to Removal and Installation. Press the power socket fixing pawls from the back of the switch panel to remove the power socket. : Pawl INSTALLATIONNote the following, and install in the reve ...

    Symptom Diagnosis. Easy Fill Tire Alert Does Not Activate
    Description The easy fill tire alert does not function while inflating a tire when the CVT shift selector position is in P-range with the ignition switch ON or with the engine started.NOTE: After starting to inflate the tire, it takes a few seconds for the easy fill tire alert to function. ...