Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Easy Fill Tire Alert Does Not Activate

Nissan Rogue (T33) 2021-Present Service Manual / Suspension :: Road Wheels & Tires / Symptom Diagnosis :: Easy Fill Tire Alert Does Not Activate

Description

The easy fill tire alert does not function while inflating a tire when the CVT shift selector position is in P-range with the ignition switch ON or with the engine started.

NOTE:

  • After starting to inflate the tire, it takes a few seconds for the easy fill tire alert to function.

  • If there is no response for approximately 15 seconds or more after inflating the tires, cancel the use of the easy fill tire alert function or move the Nissan Ariya vehicle approximately 1 m (3.2 ft) backward or forward to try again. The air filler pressure may be weak or out of service area.

  • For easy fill tire alert, Refer to Easy Fill Tire Alert Function.

Diagnosis Procedure

LOCATION CHANGE

Move the vehicle to other area and repeat the procedure of the easy fill tire alert function. Refer to Easy Fill Tire Alert Function.

Is the function normal?

YES>>

Normal (the tire inflation indicator may not operate, depending on reception condition.)

NO>>

GO TO 2.

PERFORM LOW TIRE PRESSURE MONITORING SYSTEM SELF DIAGNOSIS RESULT

CONSULT

  1. Drive for 10 minutes at a speed of 25 MPH (40 km/h) or more.

  2. Stop the Nissan Ariya vehicle.

  3. Perform “Self diagnosis result” mode of “BCM”.

Is any DTCs detected?

YES>>

Check the DTC. Refer to DTC Index.

NO>>

GO TO 3.

CHECK HAZARD WARNING LAMP OPERATION

Check hazard warning lamp operation with hazard switch.

Does the hazard warning lamp blink?

YES>>

GO TO 4.

NO>>

Perform trouble diagnosis for the hazard warning lamp. Refer to Symptom Table.

PERFORM ELECTRIC SHIFT CONTROL MODULE SELF DIAGNOSIS

CONSULT

Perform “Self diagnosis result” mode of “SHIFT”.

Is any DTCs detected?

YES>>

Check the DTC.

  • Refer to DTC Index.

NO>>

GO TO 5.

CHECK HORN OPERATION

Check horn operation.

Is the operation normal?

YES>>

GO TO 6.

NO>>

Repair or replace error-detected parts.

PERFORM BCM SELF DIAGNOSIS RESULT

CONSULT

Perform “Self diagnosis result” mode of “BCM”.

Is any DTCs detected?

YES>>

Check the DTC. Refer to DTC Index.

NO>>

Replace BCM. Refer to Removal and Installation.

    Symptom Diagnosis. Id Registration Cannot Be Completed
    Description The ID of the tire pressure sensor installed in each wheel cannot be registered in the tire pressure monitoring system. Inspect the tire pressure sensor or the tire ...
    Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting
    NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference...

    Other materials:

    Power Supply and Ground Circuit
    Diagnosis Procedure CHECK FUSE Check that the following fuse is not blown: Signal name Fuse No. Ignition power supply 40 (10 A) Is the fuse blown? YES>> Replace the blown fuse after repairing the affected circuit. NO>> GO TO 2. CHECK ADAS CONTROL UNIT 2 POWER SUPP ...

    Child safety
    Basic information WARNING Do not allow children to play with the seat belts. Most seating positions in the Nissan Rogue are equipped with Automatic Locking Retractor (ALR) mode seat belts. If a seat belt becomes wrapped around a child's neck while the ALR mode is activated, the belt can tighten a ...

    Active Noise Control Unit
    Reference Value VALUES ON THE DIAGNOSIS TOOL Monitor Item Condition Value/Status Active sound control operating condition Active sound control system is not operating. Off Active sound control system is operating. On Active noise control operating condition Active noise c ...