Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2908-11 Slide Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Body Interior :: Automatic Drive Positioner / Dtc/circuit Diagnosis :: B2908-11 Slide Sensor

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC detection condition
B2908-11 Slide Sensor Diagnosis condition The Slide Sensor signal is shorted to ground
Signal (terminal) Sliding Motor (terminal #5)
Threshold 0.00 - 0.352 V
Diagnosis delay time 100 mili- seconds or more

POSSIBLE CAUSE

  • LH Sliding Motor

  • Driver seat control unit

  • Harness or connectors

FAIL-SAFE

Stop automatic drive position function.

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON and wait for 20 seconds or more.

  2. Check “Self diagnosis result” mode of “DRIVER SEAT”.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK LIFTING MOTOR SENSOR SIGNAL

  1. Ignition switch OFF.

  2. Disconnect driver seat control unit and LH sliding motor.

  3. Check continuity between driver seat control unit harness connector and ground.

(+) (-) Continuity
Driver seat control unit
Connector Terminal
B213 35 Ground Yes

Is the inspection result normal?

YES>>

Connect driver seat control unit and LH sliding motor. Refer to Component Function Check.

NO>>

Repair the harness or connector.

    Dtc/circuit Diagnosis. B2907-31 Lift Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B2907-31 Lift Sensor Diagnosis condition When the ignition s...
    Dtc/circuit Diagnosis. B2908-12 Slide Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B2908-12 Slide Sensor Diagnosis condition When the ignition ...

    Other materials:

    U216e-87 Can Comm Circuit
    DTC Description CAN (Controller Area Network) is a serial communication system for real time application. It is an on-Nissan Ariya vehicle multiplex communication system with high data communication speed and excellent error detectability. Many electronic control units are equipped onto Nis ...

    U012e Can Communication
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U012E 00 Communication error (lost) (Lost communication with camshaft position control module) Diagnosis condition Engine running at idle Signal (terminal) C ...

    Engine Stand Setting
    Setting NOTE: Explained here is how to disassemble with engine stand supporting transaxle surface. When using different type of engine stand, note with difference in steps and etc. Remove the engine and the transaxle assembly from the vehicle, and separate the transaxle from the engine. Ref ...