Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2436-98 Spindle Motor Lh

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content)
DTC Detection Condition
B2436-98

Spindle motor LH

(Spindle motor left hand)
Diagnosis condition All times
Signal (terminal)
Threshold When thermal protection operate of the spindle motor LH
Diagnosis delay time 45 seconds or more

POSSIBLE CAUSE

Automatic back door control unit

FAIL-SAFE

Inhibit automatic back door system (only operate back door closure function)

DTC CONFIRMATION PROCEDURE

DTC CONFIRMATION

CONSULT

  1. Ignition switch ON and wait for 45 seconds or more.

  2. Select “Self diagnosis result” mode of “AUTOMATIC BACK DOOR”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK SELF DIAGNOSIS RESULT

CONSULT

  1. Wait for 75 seconds or more.

  2. Ignition switch ON.

  3. Select “Self diagnosis result” mode of “AUTOMATIC BACK DOOR”.

What is the display history of DTC “B2436-98”?

“CRNT”>>

Replace automatic back door control unit. Refer to Removal and Installation.

“PAST”>>

Inspection End.

    Dtc/circuit Diagnosis. B2436-12 Spindle Motor Lh
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B2436-12 Spindle motor LH (Spindle motor left hand) Diagnosi...
    Dtc/circuit Diagnosis. B2f06-11 Trunk/back Door Opener Sw
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B2F06-11 Back door/trunk opener switch (Back door/trunk open...

    Other materials:

    Front Blower Motor
    Diagnosis Procedure CHECK FUSE Ignition switch OFF. Check that the following fusible link are not blown (open). Unit Location Fuse No. Capacity Front blower motor Fuse block (J/B) LL 40 A Is the fuses blown (open)? YES>> Replace the blown (open) fusib ...

    Symptom Diagnosis. Automatic Back Door Functions Do Not Cancel
    Diagnosis Procedure CHECK “POWER BACK DOOR SETTING” IN COMBINATION METER Check “Power back door setting” is in the OFF. Is the inspection result normal? YES>> GO TO 2. NO>> Set “Power back door setting” to “OFF”. REPLACE AUTOMATIC BACK DOOR CONTROL UNIT Rep ...

    Dtc/circuit Diagnosis. B12b5-97 Frontal Collision
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B12B5-97 Frontal collision (Frontal collision) Diagnosis condition When ignition switch is ON. Signal (terminal) Collision signal Threshold Frontal ...