Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B1036-17 Ignition Voltage
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B1036-17 |
Ignition voltage (Ignition voltage) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | Ignition high voltage signal | ||
| Threshold | Power supply malfunction (high voltage) of air bag diagnosis sensor unit | ||
| Diagnosis delay time | 3 seconds or more. | ||
POSSIBLE CAUSE
-
Malfunction of battery voltage (16 V or more)
-
Connection malfunction of harness or connector
-
Internal malfunction of air bag diagnosis sensor unit
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CHECK SELF DIAGNOSIS RESULT
CONSULT
-
Ignition switch ON and wait for 3 seconds or more.
-
Perform “Self diagnosis result” mode of “AIR BAG” using CONSULT.
Is malfunctioning part detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End
Diagnosis Procedure
WARNING:
-
Before servicing, ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.)
-
Never use unspecified tester or other measuring device.
CHECK BATTERY VOLTAGE
Check battery voltage. Refer to Work Flow.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace the malfunctioning parts.
CHECK HARNESS CONNECTOR
Check the harness connector.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Replace harness connectors.
CHECK WIRING HARNESS
Check the wiring harness externals.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Replace wiring harness.
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
-
Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 1.
NO>>Inspection End
Other materials:
Electric Wastegate Control Actuator
Component Inspection
INSPECTION START
Do you have CONSULT?
Do you have CONSULT?
YES>>
GO TO 2.
NO>>
GO TO 3.
CHECK ELECTRIC WASTEGATE CONTROL ACTUATOR
With CONSULT
Turn ignition switch ON and engine stopped.
On the CONSULT screen, select “ENGINE”>>“ACTIVE ...
C1f41-84 Cvt
Without Propilot Assist 2.1
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1F41
84
TRANSMISSION CIRCUIT
(Transmission circuit)
Diagnosis condition
When engine is running
When AEB system is O ...
U012e Can Communication
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U012E
00
Communication error (lost)
(Lost communication with camshaft position control module)
Diagnosis condition
Engine running at idle
Signal (terminal)
C ...
