Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B1000-49 Air Bag Diagnosis Sensor Unit
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B1000-49 |
Air bag diagnosis sensor unit (Air bag diagnosis sensor unit) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | — | ||
| Threshold | Air bag diagnosis sensor unit is malfunctioning | ||
| Diagnosis delay time | 2 seconds or more. | ||
POSSIBLE CAUSE
Malfunction in air bag diagnosis sensor unit
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CHECK SELF DIAGNOSIS RESULT
CONSULT
-
Ignition switch ON.
-
Perform “Self diagnosis result” mode of “AIR BAG” using CONSULT.
Is malfunctioning part detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End
Diagnosis Procedure
WARNING:
-
Before servicing, ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.)
-
Never use unspecified tester or other measuring device.
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
-
Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>Check Intermittent incident. Refer to Intermittent Incident.
NO>>Inspection End
Other materials:
P2123 App Sensor
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P2123
00
APP SEN 1/CIRC
(Throttle/Pedal position sensor/switch D circuit high)
Diagnosis condition
Engine running at idle
Signal (terminal)
Accelerator ...
P055f Engine Oil Pressure
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P055F
Engine oil pressure
(Engine oil pressure out of range)
Diagnosis condition
After ECM self shut-off.
Engine oil temperature is more than -10 ℃(14 ...
Power Supply and Ground Circuit
Diagnosis Procedure
CHECK FUSE
Check that the following fuse is not blown:
Signal name Fuse No.
Ignition power supply
40 (10 A)
Is the fuse blown?
YES>>
Replace the blown fuse after repairing the affected circuit.
NO>>
GO TO 2.
CHECK ADAS CONTROL UNIT 2 POWER SUPP ...
