Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B0052-11 Front Seat Belt Buckle Switch Rh
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B0052–11 |
Front seat belt buckle switch RH (Passenger Seat Belt Sensor) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | Front seat belt buckle switch RH signal | ||
| Threshold | Front seat belt buckle switch RH circuit is shorted to ground | ||
| Diagnosis delay time | 2 seconds or more. | ||
POSSIBLE CAUSE
-
Connection malfunction or short circuit to ground of harness and connector
-
Internal malfunction of front seat belt buckle switch RH
-
Internal malfunction of air bag diagnosis sensor unit
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CHECK SELF DIAGNOSIS RESULT
CONSULT
-
Ignition switch ON.
-
Perform “Self diagnosis result” mode of “AIR BAG” using CONSULT.
Is malfunctioning part detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End
Diagnosis Procedure
WARNING:
-
Before servicing, ignition switch OFF, disconnect battery negative terminal and wait at least 3 minutes. (To discharge backup capacitor.)
-
Never use unspecified tester or other measuring device.
CHECK HARNESS CONNECTOR
Check the harness connector.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Replace harness connector.
CHECK WIRING HARNESS
Check the wiring harness externals.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Replace wiring harness.
REPLACE FRONT SEAT BELT BUCKLE SWITCH RH
-
Replace front seat belt buckle RH. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 4.
NO>>Inspection End
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
-
Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 1.
NO>>Inspection End
Other materials:
Dtc/circuit Diagnosis. Horn Function
Component Function Check
CHECK FUNCTION
CONSULT
Ignition switch OFF.
Perform “Horn” in “Active test” mode of “IPDM E/R”.
Check the horn operation.
Test item Description
Horn
On
Horn
Sounds (for 20 ms.)
Is the operation normal?
YES>>
Ins ...
Symptom Diagnosis. Easy Fill Tire Alert Does Not Activate
Description
The easy fill tire alert does not function while inflating a tire
when the CVT shift selector position is in P-range with the ignition
switch ON or with the engine started.NOTE:
After starting to inflate the tire, it takes a few seconds for the easy fill tire alert to function. ...
Power Supply and Ground Circuit
8ch Can Gateway
Diagnosis Procedure
CHECK FUSE
Check that the following fuse are not blown.
Signal name Fuse No.
Battery power supply
16
Ignition power supply
9
Is the fuse blown (open)?
YES>>
Replace the blown fuse after repairing the affected circuit if a fuse ...
