Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B0052-12 Front Seat Belt Buckle Switch Rh
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B0052–12 |
Front seat belt buckle switch RH (Passenger Seat Belt Sensor) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | Front seat belt buckle switch RH signal | ||
| Threshold | Front seat belt buckle switch RH circuit is shorted to power supply circuit | ||
| Diagnosis delay time | 2 seconds or more. | ||
POSSIBLE CAUSE
-
Connection malfunction or short circuit to power supply of harness and connector
-
Internal malfunction of front seat belt buckle switch RH.
-
Internal malfunction of air bag diagnosis sensor unit
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CHECK SELF DIAGNOSIS RESULT
CONSULT
-
Ignition switch ON.
-
Perform “Self diagnosis result” mode of “AIR BAG” using CONSULT.
Is malfunctioning part detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End
Diagnosis Procedure
WARNING:
-
Before servicing, ignition switch OFF, disconnect battery negative terminal and wait at least 3 minutes. (To discharge backup capacitor.)
-
Never use unspecified tester or other measuring device.
CHECK HARNESS CONNECTOR
Check the harness connector.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Replace harness connector.
CHECK WIRING HARNESS
Check the wiring harness externals.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Replace wiring harness.
REPLACE FRONT SEAT BELT BUCKLE SWITCH RH
-
Replace front seat belt buckle RH. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 4.
NO>>Inspection End
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
-
Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 1.
NO>>Inspection End
Other materials:
B2723-88 Corner Sensor [rr]
DTC Description
DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition
B2723-88
CORNER SENSOR [RR]
(Corner sensor [RR])
Diagnosis condition
When ignition switch is ON
Signal (terminal)
—
Threshold
Communication error
D ...
C0513 Wheel Speed Sensor
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
C0513
00
Right rear wheel speed sensor
(Right Rear Wheel Speed Sensor Range/Performance)
Diagnosis condition
Ignition switch ON
Battery voltage: 11 V ...
Information Display (combination Meter)
Door Open Warning
DESIGN/PURPOSEInformation display warns the driver that each door is open or is not fully closed. Symbol Message
–
SYNCHRONIZATION WITH MASTER WARNING LAMPSynchronization is applied.Refer to Master Warning Lamp.SYSTEM DIAGRAMSIGNAL PATH
BCM transmits door switch ...
