Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B0052-13 Front Seat Belt Buckle Switch Rh
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B0052–13 |
Front seat belt buckle switch RH (Passenger Seat Belt Sensor) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | Front seat belt buckle switch RH signal | ||
| Threshold | Front seat belt buckle switch RH circuit is open | ||
| Diagnosis delay time | 2 seconds or more. | ||
POSSIBLE CAUSE
-
Connection malfunction or open circuit of harness and connector
-
Internal malfunction of front seat belt buckle switch RH
-
Internal malfunction of air bag diagnosis sensor unit
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CHECK SELF DIAGNOSIS RESULT
CONSULT
-
Ignition switch ON.
-
Perform “Self diagnosis result” mode of “AIR BAG” using CONSULT.
Is malfunctioning part detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End
Diagnosis Procedure
WARNING:
-
Before servicing, ignition switch OFF, disconnect battery negative terminal and wait at least 3 minutes. (To discharge backup capacitor.)
-
Never use unspecified tester or other measuring device.
CHECK HARNESS CONNECTOR
Check the harness connector.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Replace harness connector.
CHECK WIRING HARNESS
Check the wiring harness externals.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Replace wiring harness.
REPLACE FRONT SEAT BELT BUCKLE SWITCH RH
-
Replace front seat belt buckle RH. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 4.
NO>>Inspection End
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
-
Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 1.
NO>>Inspection End
Other materials:
U2e52-87 Can Comm Circuit
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition
U2E52
87
CAN communication error (ADAS control unit)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
CAN communication signal
Threshold
Not receiving from ADAS c ...
Charge Air Cooler
Exploded View
Charge air cooler
Charge air cooler Bracket 1
Turbocharger boost sensor (with intake air temperature sensor 2)
O-ring
Electronic throttle control actuator gasket
Charge air cooler Bracket 2
Air inlet hose
To r ...
Brake assist
Brake assist
When brake pedal force exceeds a certain
threshold, Brake Assist activates to provide
greater braking force than a conventional
brake booster, even with relatively light pedal
pressure.
WARNING
Brake Assist supports braking but does
not replace careful driving. It is not a collision
wa ...
