Nissan Rogue (T33) 2021-Present Service Manual: Power Supply and Ground Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can Gateway :: Dtc Diagnosis [8ch Can Gateway (8ch Can Gateway)] / Power Supply and Ground Circuit

8ch Can Gateway

Diagnosis Procedure

CHECK FUSE

Check that the following fuse are not blown.

Signal name Fuse No.
Battery power supply 16
Ignition power supply 9

Is the fuse blown (open)?

YES>>

Replace the blown fuse after repairing the affected circuit if a fuse is blown.

NO>>

GO TO 2.

CHECK POWER SUPPLY CIRCUIT

  1. Turn the ignition switch OFF.

  2. Disconnect the connector of 8CH CAN gateway.

  3. Check voltage between 8CH CAN gateway harness connector and ground.

    • With Type B Meter

      Terminals Condition

      Voltage

      (Standard)

      Voltage

      (Reference value)
      (+) (−)
      8CH CAN gateway Ground Ignition switch
      Connector Terminal
      M16 1 OFF 6 – 16 V

      Battery

      voltage
      17 ON 7 – 16 V

      Battery

      voltage

    • With Type A Meter

      Terminals Condition

      Voltage

      (Standard)

      Voltage

      (Reference value)
      (+) (−)
      8CH CAN gateway Ground Ignition switch
      Connector Terminal
      M9 37 OFF 6 – 16 V

      Battery

      voltage
      53 ON 7 – 16 V

      Battery

      voltage

Is the measurement value normal?

YES>>

GO TO 3.

NO>>

Repair harness or connector.

CHECK GROUND CIRCUIT

Check continuity between 8CH CAN gateway harness connector and ground.

  • With Type B Meter

    8CH CAN gateway Ground Continuity
    Connector Terminal
    M16 21 Existed
    28

  • With Type A Meter

    8CH CAN gateway Ground Continuity
    Connector Terminal
    M9 57 Existed
    64

Does continuity exist?

YES>>

INSPECTION END

NO>>

Repair harness or connector.

    U2a8c-88 Ethernet Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition U2A8C-88 Ethernet circuit Diagnosis condition When ignition switch is ON. Signal (termina...
    Can Gateway. Wiring Diagram. Can Gateway System
    Can Gateway System Wiring Diagram CAN GATEWAY SYSTEM - WITH TYPE A METERRefer to Wiring Diagram.CAN GATEWAY SYSTEM - WITH TYPE B METERRefer to Wiring Diagram.

    Other materials:

    Ignition Coil with Power Transistor
    Component Inspection CHECK IGNITION COIL WITH POWER TRANSISTOR-1 Turn ignition switch OFF. Disconnect ignition coil harness connector. Check resistance between ignition coil terminals as per the following. Ignition coil Condition Resistance + − Terminal 1 ...

    Système temporairement indisponible
    Lorsqu’un blocage est détecté au niveau du radar latéral, le système BSW du Nissan Rogue se désactive automatiquement afin de garantir la sécurité. Un avertissement sonore retentit et le message d’alerte « Non disponible Obstruction radar latérale » s’affiche clairement sur l’écra ...

    Structure and Operation
    Positive Crankcase Ventilation In a supercharged engine, since the negative pressure in the intake manifold is insufficient, the blow-by gas in the crankcase cannot be sufficiently ventilated with a usual PCV valve only.The negative pressure generated even in the supercharging range can be ...