Nissan Rogue (T33) 2021-Present Service Manual: Periodic Maintenance :: Body Maintenance
Locks, Hinges and Hood Latch
Lubricating
For hood illustration. Refer to Exploded View.
For hood lock illustration. Refer to Exploded View.
For front door illustration. Refer to Exploded View.
For rear door illustration. Refer to Exploded View.
For back door illustration. Refer to Exploded View.
For back door lock illustration. Refer to Exploded View.
Seat Belt, Buckles, Retractors, Anchors and Adjusters
Inspection
For front seat belt illustration. Refer to Exploded View.
For rear seat belt illustration. Refer to Exploded View.
CAUTION:
-
After any collision, inspect all seat belt assemblies, including retractors and other attached hardwares (I.e. anchor bolt, guide rail set). Nissan recommends to replace all seat belt assemblies in use during a collision, unless not damaged and properly operating after minor collision.
Also inspect seat belt assemblies not in use during a collision, and replace if damaged or improperly operating.
Seat belt pre-tensioner should be replaced even if the seat belts are not in use during a frontal collision where the driver and passenger air bags are deployed.
-
If any component of seat belt assembly is questionable, do not repair.
Replace as seat belt assembly.
-
If webbing is cut, frayed, or damaged, replace belt assembly.
-
Never oil tongue and buckle.
-
Use a genuine NISSAN seat belt assembly.
For details, refer to Inspection , Inspection in SB section.
-
Check anchors for loose mounting
-
Check belts for damage
-
Check retractor for smooth operation
-
Check function of buckles and tongues when buckled and released
Other materials:
Basic Inspection. Tire Pressure Sensor Id Registration
Description
This procedure must be performed.
After replacement of a tire pressure sensor or BCM.
After replacement of tire or road wheel.
NOTE:
ID registration is unnecessary if there are no change in
the positions of each wheels (tire pressure sensors) before wheel
removal and after ...
C1051-04 Pump Motor
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1051
04
Pump motor
(Pump motor)
Diagnosis condition
When ignition switch is ON.
When the power supply voltage is normal.
Signal (terminal)
...
Power Distribution System. Ecu Diagnosis Information. Bcm, Ipdm E/r, Intelligent Key Unit
Bcm, Ipdm E/r, Intelligent Key Unit
List of ECU Reference
ECU Reference
BCM
Reference Value
Fail-safe
DTC Inspection Priority Chart
DTC Index
IPDM E/R
Values on the Diagnosis Tool
Reference Value
Fail-safe
DTC Inspection Priority Chart
DTC Index
...
