Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B0002-55 Driver Airbag Module 2
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B0002-55 |
DRIVER AIRBAG MODULE 2 (Driver Frontal Stage 2 Deployment Control) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | Driver air bag module signal | ||
| Threshold | When a mismatch is detected between in the configuration data stored in the air bag diagnosis sensor unit and Nissan Ariya vehicle specification. | ||
| Diagnosis delay time | 2 seconds or more. | ||
POSSIBLE CAUSE
-
Connection malfunction of harness and connector
-
Mistake of configuration for air bag diagnosis sensor unit
-
Internal malfunction of air bag diagnosis sensor unit
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CHECK SELF-DIAGNOSIS RESULT
CONSULT
-
Ignition switch ON.
-
Perform “Self diagnosis result” mode of “AIR BAG” using CONSULT.
Is malfunctioning part detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End
Diagnosis Procedure
WARNING:
-
Before servicing, ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.)
-
Never use unspecified tester or other measuring device.
CHECK HARNESS CONNECTOR
Check the harness connector.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Replace harness connector.
CHECK WIRING HARNESS
Check the wiring harness externals.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Replace wiring harness.
PERFORM CONFIGURATION
-
Perform configuration for air bag diagnosis sensor unit. Refer to Description.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 4.
NO>>Inspection End
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
-
Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 1.
NO>>Inspection End
Other materials:
P02cd Fuel Injector
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P02CD
00
CYL1 INJECTOR OFFSET LEARNING
(Cylinder 1 Fuel Injector "A" Offset Learning At Max Limit)
Diagnosis condition
Engine running
During injector ...
Steering Switch Signal B Circuit
Component Function Check
CHECK COMBINATION METER INPUT SIGNAL
CONSULT
Ignition switch ON.
Select “Steering switch input” in “Data monitor” mode of “M&A”.
Check that the function operates normally according to the following conditions:
Condition Value
CONTRO ...
P2135 Tp Sensor
DTC Description
DTC DETECTION LOGICNOTE:
If DTC P2135 is displayed with DTC P06B0, first perform the trouble diagnosis for DTC P06B0. Refer to DTC Description.
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P2135
00
TP SENSOR-B1
(Throttle/Pedal ...
