Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Changing a flat tire

Basic information

If you experience a flat tire, follow the procedure below to safely replace it.

Stopping the vehicle

1. Safely move your vehicle off the roadway and away from traffic.

2. Turn on the hazard warning flashers.

3. Park on a flat, level surface and apply the parking brake.

4. Push the park button to shift into the P (Park) position.

5. Turn off the engine.

6. Raise the hood to alert other drivers and signal roadside assistance personnel.

7. Have all passengers exit the vehicle and stand in a safe area away from traffic.

WARNING

• Ensure the parking brake is fully applied and the vehicle is securely in P (Park).
• Never attempt to change a tire on a slope, ice, or slippery surfaces. This is extremely dangerous.
• If traffic is passing close to your vehicle, do not attempt to change the tire. Wait for professional assistance.

Blocking wheels

Place suitable blocks 1 both in front of and behind the wheel opposite the flat tire. This prevents the vehicle from rolling while it is raised by the jack.

WARNING

Always block the wheels. Failure to do so may allow the vehicle to move and could cause personal injury.

Models with adjustable luggage floor

Getting the spare tire and tools

The jack, tools, and spare tire are stored in the luggage compartment.

To remove the jack:

1. Open the storage door by pressing both release tabs.

2. Turn the jack lever counterclockwise and remove the jack slowly.

When storing the jack, place it back carefully, then turn the lever clockwise to secure it.

CAUTION

Be careful not to injure your hands when removing the jack.

NOTE:

• Do not overtighten the jack lever when storing the jack. This may deform the mounting area.
• Ensure the jack does not contact interior trim parts to avoid damage.

Models with adjustable luggage floor (example)

Removing the spare tire and tools

The spare tire and tools are located beneath the luggage floorboard(s).

To access them:

1. Remove the luggage floorboard(s).

– Models with adjustable floor: Unlock before lifting the rear (outer) board.
– Models with single board: Release the retainer pins.

2. Remove the floor carpet (if equipped). Then remove the tool bag from the storage compartment.

Remove the spare tire by loosening and removing the holding clamp.

Example

Removing the spare tire with subwoofer (if equipped)

1. Turn the bolt counterclockwise to loosen it.

2. Remove the bolt completely.

Example

3. Place the subwoofer in the left corner of the cargo area.

4. Remove the spare tire.

5. After installing the spare in place of the flat tire, store the flat tire in the spare tire area.

6. Place the subwoofer inside the flat tire.

7. Tighten the bolt by turning it clockwise.

© 2014-2025 Copyright www.nirogue.com