Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Tire Pressure Monitoring System (TPMS)
This vehicle is equipped with the Tire Pressure Monitoring System (TPMS), which continuously monitors the air pressure in all tires except the spare. If the low tire pressure warning light illuminates and the “Tire Pressure Low – Add Air” message appears in the vehicle information display, at least one tire is significantly under-inflated. When tire pressure drops below the recommended level and the vehicle is driven above 16 MPH (25 km/h), the TPMS activates and provides a warning.
WARNING
- If the low tire pressure warning light comes on while driving, avoid sudden steering or abrupt braking. Reduce speed carefully, pull off the road to a safe location, and stop the vehicle as soon as possible. Driving with significantly under-inflated tires can permanently damage the tires, increase the risk of tire failure, and may lead to an accident causing serious personal injury.
- After stopping, check the pressure of all four tires and adjust them to the recommended COLD tire pressure listed on the Tire and Loading Information label. This will turn the warning light OFF. If the warning light stays on even after adjusting air pressure, one of the tires may be flat and must be replaced with the spare tire promptly.
- The spare tire is not equipped with TPMS. When a spare tire is installed or when a wheel without a sensor is mounted, the TPMS will not operate. In this case, the low tire pressure warning light will flash for about one minute and then stay illuminated. Replace the tire and/or have the TPMS reset as soon as possible.
It is recommended that these services be performed by a NISSAN dealer.
- Do not install tires of a size or type different from those originally specified by NISSAN, as doing so may affect TPMS performance.
- Do not inject tire sealants or aerosol puncture repair substances into any tire, as these can cause TPMS sensor malfunction.
Basic information
If you experience a flat tire, follow the procedure below to safely replace it.
Stopping the vehicle
1. Safely move your vehicle off the roadway and away from traffic.
2. Turn on th ...
Other materials:
Periodic maintenance
REAR PROPELLER SHAFT
Inspection
APPEARANCE AND NOISE
Check the propeller shaft tube surface for dents or cracks. If
malfunction is detected, replace propeller shaft
assembly.
If center bearing is noisy or damaged, replace propeller shaft
assembly.
VIBRATION
If vibrati ...
C1111 pump motor
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1111
PUMP MOTOR
When a malfunction is detected in motor or motor relay.
Harness or connector
ABS actuator and electric unit
(control unit)
&nb ...
Unit removal and installation
ENGINE ASSEMBLY
Exploded view
Engine mounting insulator (RH)
Upper torque rod (RH)
Engine mounting bracket (RH)
Lower torque rod
Torque rod bracket
Engine mounting insulator (LH)
Removal and installation (FWD)
WARNING:
Situate the vehicl ...
© 2014-2025 Copyright www.nirogue.com