Nissan Rogue (T33) 2021-Present Service Manual: Ccm Branch Line Circuit (chassis Can Communication 2 Circuit)

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can :: Dtc/circuit Diagnosis / Ccm Branch Line Circuit (chassis Can Communication 2 Circuit)

Diagnosis Procedure

CHECK CONNECTOR

  1. Ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Check the terminals and connectors of the chassis control module for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the terminal and connector.

CHECK HARNESS FOR OPEN CIRCUIT

  1. Disconnect the connector of chassis control module.

  2. Check the resistance between the chassis control module harness connector terminals.

    Chassis control module harness connector Resistance (Ω)
    Connector No. Terminal No.
    M32 24 7 Approx. 54 – 66

Is the measurement value within the specification?

YES>>

GO TO 3.

NO>>

Repair the chassis control module branch line.

CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the chassis control module. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

Present error: Replace the chassis control module. Refer to Removal and Installation.

YES>>

Past error: Error was detected in the chassis control module branch line.

NO>>

Repair the power supply and the ground circuit.

    Pnsr Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the power network separat...
    Brake Branch Line Circuit (chassis Can Communication 2 Circuit)
    Diagnosis Procedure CHECK CONNECTOR Ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the electrically-driven i...

    Other materials:

    Symptom Diagnosis. Easy Fill Tire Alert Does Not Activate
    Description The easy fill tire alert does not function while inflating a tire when the CVT shift selector position is in P-range with the ignition switch ON or with the engine started.NOTE: After starting to inflate the tire, it takes a few seconds for the easy fill tire alert to function. ...

    Dtc/circuit Diagnosis. U0075-00 Communication Bus C Off
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition U0075-00 Control module comm Bus C Off (Control module communication Bus C Off) Diagnosis condition Ignition switch ON Signal (terminal) CAN communication s ...

    Door Lock Function
    System Description SYSTEM DIAGRAMDoor lock function controls operation function of the following items. Door lock and unlock function (door request switch) Selective unlock function (door request switch) Reminder function (door request switch) Auto door lock function (door request ...