Nissan Rogue (T33) 2021-Present Service Manual: C1f8a-04 Side Radar Rh
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| C1F8A | 04 |
Side radar rear RH (Side radar rear right hand) |
Diagnosis condition | When engine is running |
| Signal (terminal) | — | |||
| Threshold | ADAS control unit 2 detects that side radar RH has a malfunction. | |||
| Diagnosis delay time | 2 seconds or more | |||
POSSIBLE CAUSE
Side radar RH
FAIL-SAFE
The following systems are canceled.
-
BSW
-
I-BSI
-
RCTA
CONFIRMATION PROCEDURE
CHECK SELF-DIAGNOSIS RESULTS
If DTC “C1F8A-04” is displayed with Network-DTC, first diagnose the Network-DTC.
Is applicable DTC detected?
YES>>Perform diagnosis of applicable. Refer to DTC Index.
NO>>GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
-
Start the engine.
-
Perform “All DTC Reading” with CONSULT.
-
Check if the “C1F8A-04” is detected as the current malfunction in “Self Diagnostic Result” of “ICC/ADAS 2”.
Is “C1F8A-04” detected as the current malfunction?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
CHECK SELF-DIAGNOSIS RESULTS
If DTC “C1F8A-04” is displayed with Network-DTC, first diagnose the Network-DTC.
Is applicable DTC detected?
YES>>Perform diagnosis of applicable. Refer to DTC Index.
NO>>GO TO 2.
CHECK SELF-DIAGNOSIS RESULTS
Check if any DTC is detected in “Self Diagnostic Result” of “Side radar (Rear right)”.
Is any DTC detected?
YES>>Perform diagnosis on the detected DTC and repair or replace the malfunctioning parts. Refer to DTC Index.
NO>>Replace the ADAS control unit 2. Refer to Removal and Installation.
Other materials:
U216e-87 Can Comm Circuit
DTC Description
CAN (Controller Area Network) is a serial communication system for
real time application. It is an on-Nissan Ariya vehicle multiplex
communication system with high data communication speed and excellent
error detectability. Many electronic control units are equipped onto
Nis ...
Steering Switch Signal B Circuit
Component Function Check
CHECK COMBINATION METER INPUT SIGNAL
CONSULT
Ignition switch ON.
Select “Steering switch input” in “Data monitor” mode of “M&A”.
Check that the function operates normally according to the following conditions:
Condition Value
CONTRO ...
U224a-87 Can Comm Err (awd/4wd)
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U224A
87
CAN comm err (AWD/4WD)
[Controller area network communication error (AWD/4WD control unit)]
1
Diagnosis condition
When ignition switch is ON.
...