Nissan Rogue (T33) 2021-Present Service Manual: C1b81-55 Control Module

Nissan Rogue (T33) 2021-Present Service Manual / Cruise Control & Driver Assistance :: Driver Assistance System / Chassis Control :: Dtc/circuit Diagnosis / C1b81-55 Control Module

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms DTC detection condition
C1B81 55 Configuration not completed Diagnosis condition When ignition switch is ON.
Signal (terminal) -
Threshold When configuration is not complete.
Diagnosis delay time 1 second or less

POSSIBLE CAUSE

  • Incomplete configuration of chassis control module

  • Chassis control module

FAIL-SAFE

The following functions are suspended.

  • Intelligent trace control function

  • Active ride control function

  • Automatic brake hold function

  • Drive mode selector function

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

CHECK DTC DETECTION

With CONSULT

  1. Ignition switch OFF to ON.

    CAUTION:

    Be sure to wait of 10 seconds after ignition switch OFF or ON.

  2. Perform self-diagnosis for “CHASSIS CONTROL”.

Is DTC “C1B81-55” detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

PERFORM SELF-DIAGNOSIS

With CONSULT

  1. Erase self-diagnosis result for “CHASSIS CONTROL”.

  2. Ignition switch OFF and wait for 10 seconds or more.

  3. Ignition switch ON.

  4. Perform self-diagnosis for “CHASSIS CONTROL”.

Is DTC “C1B81-55” detected?

YES>>

Perform configuration. Refer to Description.

NO>>

INSPECTION END

    C1b80-54 Control Module
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition C1B80 54 Calibration not completed Diagnosis condition When ignition switch is ON. Signa...
    C1b8b-82 Hardware Network Seperator System
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition C1B8B 82 Power network separate relay Diagnosis condition When ignition switch is ON. Si...

    Other materials:

    B2723-88 Corner Sensor [rr]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2723-88 CORNER SENSOR [RR] (Corner sensor [RR]) Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold Communication error D ...

    Repair Information. Preparation
    Repairing Material Foam Repair During factory body assembly, foam insulators are installed in certain body panels and locations around the Nissan Ariya vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.URETHANE FOAM APPLICATIONSUse commercially availabl ...

    U224a-87 Can Comm Err (awd/4wd)
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U224A 87 CAN comm err (AWD/4WD) [Controller area network communication error (AWD/4WD control unit)] 1 Diagnosis condition When ignition switch is ON. ...