Nissan Rogue (T33) 2021-Present Service Manual: C1220-54 Incomplete Air Bleeding

Nissan Rogue (T33) 2021-Present Service Manual / Transmission & Driveline :: Driveline / Transfer: Ty92a :: Dtc/circuit Diagnosis / C1220-54 Incomplete Air Bleeding

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detecting condition
C1220-54

INCOMP AIR BLEEDING

(Incomplete air bleeding) 		Diagnosis condition Ignition switch: ON
Signal —
Threshold Air bleeding of electro-hydraulic coupling oil was incomplete.
Diagnosis delay time —

POSSIBLE CAUSE

  • Incomplete air bleeding of electro-hydraulic coupling oil

  • Electro-hydraulic coupling

FAIL-SAFE

Although AWD control is canceled, the vehicle can drive at 2WD condition.

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place ignition switch OFF and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

DTC REPRODUCTION PROCEDURE

CONSULT

  1. Erase "Self diagnosis result" mode of “AWD/4WD”.

  2. Ignition switch OFF.

  3. Wait for 10 seconds or more.

  4. Ignition switch ON.

  5. Wait for 15 seconds or more.

  6. Perform "Self diagnosis result" mode of “AWD/4WD”.

Is DTC “C1220-54” detected?

YES>>

Proceed to diagnosis procedure. Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

PERFORM AIR BLEEDING AND INITIALIZE OIL DETERIORATION LEVEL

CONSULT

  1. Perform air bleeding and initialize oil deterioration level. Refer to Description.

  2. Ignition switch OFF.

  3. Perform the “DTC CONFIRMATION PROCEDURE”. Refer to DTC Description.

Is DTC “C1220-54” detected again?

YES>>

Replace electro-hydraulic coupling assembly. Refer to Removal and Installation.

NO>>

Inspection End.

    C1215-12 Oil Temperature Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition C1215-12 OIL TEMPERATURE SENSOR (Oil temperature sensor) Diagnos...
    U3d02-06 Incomplete Programming
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition U3D02-06 INCOMP PROGRAMMING (Incomplete programming) Diagnosis c...

    Other materials:

    Comment activer/désactiver le système de sonar
    Commandes au volant (côté gauche) Écran d’informations du véhicule Le système de sonar du Nissan Rogue est automatiquement activé lorsque le contact d’allumage est placé sur la position ON et que le levier de vitesses est engagé sur D (conduite) ou R (marche arrière). Pou ...

    P0261 Fuel Injector (cylinder 1)
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0261 00 CYL1 INJECTOR (Cylinder 1 Injector A Circuit Low) Diagnosis condition — Signal (terminal) — Threshold Direct injector driver unit ...

    Ivc Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). TCU 8CH CAN gateway Is the ...