Nissan Rogue (T33) 2021-Present Service Manual: C1213-A2 Control Unit Power Supply

Nissan Rogue (T33) 2021-Present Service Manual / Transmission & Driveline :: Driveline / Transfer: Ty92a :: Dtc/circuit Diagnosis / C1213-A2 Control Unit Power Supply

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detecting condition
C1213-A2

BATTERY VOLTAGE

(Battery voltage) 		Diagnosis condition Ignition switch: ON
Signal Battery power supply signal (terminal #6)
Threshold Battery power supply signal < 9 V
Diagnosis delay time 15 seconds or more

POSSIBLE CAUSE

The power supply in the system is too low.

FAIL-SAFE

Although AWD control is canceled, the vehicle can drive at 2WD condition.

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place ignition switch OFF and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

DTC REPRODUCTION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Drive at 10 km/h (6 MPH) or more for approximately 5 minutes in urban areas.

  3. Stop the Nissan Ariya vehicle.

  4. Perform "Self diagnosis result" mode of “AWD/4WD”.

Is DTC “C1213-A2” detected?

YES>>

Proceed to diagnosis procedure. Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK POWER SUPPLY AND GROUND CIRCUIT

Perform the trouble diagnosis of the power supply and ground circuit. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace error-detected parts.

CHECK TERMINALS AND HARNESS CONNECTORS

Check AWD control unit pin terminals for damage or loose connection with harness connector.

Is the inspection result normal?

YES>>

After placing the ignition switch OFF, perform DTC confirmation procedure again. If DTC “C1213-A2” is detected, replace actuator assembly due to the malfunction of the AWD control unit. Refer to Disassembly and Assembly .

NO>>

Repair or replace error-detected parts.

    C1210-97 Ecm Signal
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition C1210-97 ENGINE SIGNAL (Engine signal) Diagnosis condition Ignit...
    C1215-12 Oil Temperature Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition C1215-12 OIL TEMPERATURE SENSOR (Oil temperature sensor) Diagnos...

    Other materials:

    Windshield wiper blades
    Cleaning Basic information If the windshield of your Nissan Rogue remains unclear after using the washer, or if the wiper blades chatter, wax or debris may be present on the glass or the blades. Clean the windshield with washer solution or mild detergent. A clean surface will not form water be ...

    C106c-01 Pressure Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C106C 01 Pressure sensor (Pressure sensor) Diagnosis condition When ignition switch is ON. When the power supply voltage is normal. Signal (t ...

    Intelligent Around View Monitor. Symptom Diagnosis
    Intelligent Around View Monitor Symptom Table INTELLIGENT AROUND VIEW MONITOR SYSTEM Symptoms Check items Probable malfunction location Screen is not switched to camera image, when camera switch is pressed and when shift position is shifted to the reverse position. “AVM” is not dis ...