Nissan Rogue (T33) 2021-Present Service Manual: C107a-55 Not Configuration

DTC Description

DTC DETECTION LOGIC

POSSIBLE CAUSE

NOTE:

Confirm if DTC is PAST or CRNT. If DTC is CRNT, proceed with Diagnosis Procedure. If DTC is PAST, clear DTC. Do not replace the ABS actuator and electric unit (control unit) for a PAST DTC.

FAIL-SAFE

Normal control

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF (Auto ACC function OFF) before conducting the next test.

GO TO 2.

CHECK DTC DETECTION

CONSULT

1. Ignition switch OFF (Auto ACC function OFF).

2. Start the engine.

   NOTE:

   Wait at least 10 seconds after start the engine.

3. Perform self-diagnosis for “ABS”.

Is DTC “C107A-55” detected?

“CRNT” is displayed: Refer to Diagnosis Procedure.

“PAST” is displayed: Inspection End (Erase the memory of self-diagnosis results.)

To check malfunction symptom before repair: Refer to Intermittent Incident.

Confirmation after repair: Inspection End

Diagnosis Procedure

PROGRAMMING OF ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

Perform programming of ABS actuator and electric unit (control unit). Refer to Work Procedure.

CAUTION:

Do not replace the ABS actuator and electric unit (control unit) until self-diagnosis has been completed.

GO TO 2.

CHECK SELF-DIAGNOSIS

CONSULT

Replace the ABS actuator and electric unit (control unit) even if other DTCs are displayed along with “C107A-55” in self-diagnosis for “ABS”.

Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.