Nissan Rogue (T33) 2021-Present Service Manual: B3a71 Intelligent Battery Sensor
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| B3A71 | 00 |
IBS Battery Current Sensor Failure (Open Circuit) [IBS battery current sensorfailure (Open circuit)] |
Diagnosis condition |
|
| Signal | 12V battery current sensor | |||
| Threshold | Temperature values above 150°C or below -50°C(302 °F or below -58 °F) . | |||
| Diagnosis delay time | 12 seconds | |||
POSSIBLE CAUSE
-
Harness or connectors (The 12V battery current sensor circuit is open or shorted.)
-
12V battery current sensor
FAIL-SAFE
Engine Control System
Not applicable
Stop/Start System
Not applicable
DTC CONFIRMATION PROCEDURE
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
-
Ignition switch OFF and wait at least 10 seconds.
-
Ignition switch ON.
-
Ignition switch OFF and wait at least 10 seconds.
>>
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
-
Ignition switch ON.
-
Check DTC.
Is DTC detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
CHECK 12V BATTERY CURRENT SENSOR CIRCUIT
Check 12V battery current sensor. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Replace error-detected parts.
Other materials:
P0264 Fuel Injector (cylinder 2)
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0264
00
CYL2 INJECTOR
(Cylinder 2 Injector "A" Circuit Low)
Diagnosis condition
—
Signal (terminal)
—
Threshold
Direct injector driver uni ...
B20a4-87 Headlamp (lh) Lin Communication
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC detection condition
B20A4–87
Headlamp (LH) LIN communication
[Headlamp (left hand) local interconnect network communication]
[MISSING MESSAGE]
Diagnosis condition
Ignition switch ...
Electric Wastegate Control Actuator
Component Inspection
INSPECTION START
Do you have CONSULT?
Do you have CONSULT?
YES>>
GO TO 2.
NO>>
GO TO 3.
CHECK ELECTRIC WASTEGATE CONTROL ACTUATOR
With CONSULT
Turn ignition switch ON and engine stopped.
On the CONSULT screen, select “ENGINE”>>“ACTIVE ...
