Nissan Rogue (T33) 2021-Present Service Manual: B3a70 Intelligent Battery Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / B3a70 Intelligent Battery Sensor

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
B3A70 00

IBS Battery Temp Sensor Failure (Open Circuit)

[IBS battery temp sensor failure (Open circuit)] 		Diagnosis condition

  • Ignition switch ON

  • Battery voltage: More than 11 V

  • LIN communication between 12V battery current sensor and IPDM E/R is normal.
Signal 12V battery current sensor
Threshold Current value is more than 500A or less than -1500A.
Diagnosis delay time 12 seconds

POSSIBLE CAUSE

  • Harness or connectors (The 12V battery current sensor circuit is open or shorted.)

  • 12V battery current sensor

FAIL-SAFE

Engine Control System

Not applicable

Stop/Start System

Not applicable

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Ignition switch OFF and wait at least 10 seconds.

  2. Ignition switch ON.

  3. Ignition switch OFF and wait at least 10 seconds.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Ignition switch ON.

  2. Check DTC.

Is DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK 12V BATTERY CURRENT SENSOR CIRCUIT

Check 12V battery current sensor. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace error-detected parts.

    Trouble Diagnosis - Specification Value
    Component Function Check START Make sure that all of the following conditions are satisfied. Nissan Ariya Vehicle driven distance: More than 5,000 km (3,107 miles) Atmospheric p...
    C0069 G Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C0069 00 Yaw Rate/Longitude Sensors (Yaw Rate/Longitude Sensors)...

    Other materials:

    Chassis Control. Basic Inspection
    Diagnosis and Repair Work Flow Work Flow DETAILED FLOWINTERVIEW FROM THE CUSTOMER Clarify customer complaints before inspection. First of all, perform an interview utilizing Diagnostic Work Sheet and reproduce the symptom as well as fully understand it. Ask customer about his/her complaints ...

    P025c Fuel Pump Relay
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P025C 00 Fuel pump module A (Fuel Pump Module "A" Control Circuit Low) Diagnosis condition Engine running Signal (terminal) — Threshold An ex ...

    Meter Speaker Signal Circuit
    Diagnosis Procedure CHECK METER SPEAKER CIRCUIT FOR OPEN Ignition switch OFF. Disconnect combination meter harness connector and meter speaker harness connector. Check the continuity between combination meter harness connector and meter speaker harness connector. Combination meter ...