Nissan Rogue (T33) 2021-Present Service Manual: C0069 G Sensor
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| C0069 | 00 |
Yaw Rate/Longitude Sensors (Yaw Rate/Longitude Sensors) |
Diagnosis condition |
|
| Signal | CAN communication signal | |||
| Threshold | When some DTC is detected in the VDC and via CAN communication is sent to the ECM | |||
| Diagnosis delay time | 12 seconds or more | |||
POSSIBLE CAUSE
-
G sensor
FAIL-SAFE
Engine Control System
Not applicable
Stop/Start System
Not applicable
DTC Confirmation Procedure
CHECK DTC
Perform the confirmation procedure for displayed DTC with VDC. Refer to below:
-
DTC C1070-64: Refer to DTC Description.
-
DTC C1071-61: Refer to DTC Description.
-
DTC C1071-64: Refer to DTC Description.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
CHECK DTC
Perform the confirmation procedure for displayed DTC with VDC. Refer to below:
-
DTC C1070-64: Refer to Diagnosis Procedure.
-
DTC C1071-61: Refer to Diagnosis Procedure.
-
DTC C1071-64: Refer to Diagnosis Procedure.
Is inspection result normal?
YES>>INSPECTION END
NO>>Repair or replace error-detected parts.
Other materials:
U0402 Can Communication
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
U0402
00
Invalid data (TCM)
(Invalid Data Received From TCM)
Diagnosis condition
Ignition switch ON
Signal (terminal)
—
Threshold
When ECM is ...
U1321-55 Configuration Unfinished
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U1321–55
Config unfinished
(Configuration unfinished)
Diagnosis condition
When ignition switch is ON
Signal (terminal)
—
Threshold
Configuration ...
Entretien général
Informations de base
Lors de l’utilisation normale de votre Nissan Rogue, les opérations d’entretien général doivent être réalisées régulièrement et avec rigueur, conformément aux instructions décrites dans cette section. Toute apparition de bruits anormaux, de vibrations inhabituelle ...
