Nissan Rogue (T33) 2021-Present Service Manual: B3a72 Intelligent Battery Sensor

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
B3A72 00

USM Voltage Measurement Failure

(Open Circuit)

[USM voltage measurement failure (Open circuit)]
Diagnosis condition
  • Ignition switch ON

  • Battery voltage: More than 11 V

Signal
Threshold Voltage value above 17.9V or voltage value below 4.8V.
Diagnosis delay time 60 seconds

POSSIBLE CAUSE

  • Harness or connectors (The IPDM E/R circuit is open or shorted.)

  • IPDM E/R

FAIL-SAFE

Engine Control System

Not applicable

Stop/Start System

Not applicable

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Ignition switch OFF and wait at least 10 seconds.

  2. Ignition switch ON.

  3. Ignition switch OFF and wait at least 10 seconds.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Ignition switch ON.

  2. Check DTC.

Is DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK IPDM E/R CIRCUIT

Check IPDM E/R. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace error-detected parts.

    B3a71 Intelligent Battery Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition B3A71 00 IBS Battery Current Sensor Failure (Open Circuit) [IBS ...
    B3a73 Intelligent Battery Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition B3A73 00 IBS temperature sensor Range/Performance (Mutual Compar...

    Other materials:

    B2723-88 Corner Sensor [rr]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2723-88 CORNER SENSOR [RR] (Corner sensor [RR]) Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold Communication error D ...

    Corrosion protection
    Most common factors contributing to vehicle corrosion Moisture-retaining dirt and debris build-up inside body cavities or seams. Paint or coating damage caused by gravel, small stones or minor collisions. Environmental factors influencing corrosion rate Moisture Sand, dirt and water accumulat ...

    C106e-54 Steering Angle Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C106E 54 Steering angle sensor (Steering angle sensor) Diagnosis condition When ignition switch is ON. When the power supply voltage is normal. ...