Nissan Rogue (T33) 2021-Present Service Manual: B24b4-02 A/c Control Comm

Nissan Rogue (T33) 2021-Present Service Manual / Ventilation, Heater & Air Conditioner :: Heater & Air Conditioning Control System / Automatic Air Conditioning :: Dtc/circuit Diagnosis / B24b4-02 A/c Control Comm

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
B24B4-02

A/C CONTROL COMM

(Air conditioning control communication) 		Diagnosis condition Ignition switch ON
Signal (Terminal) LIN (A/C switch assembly) signal
Threshold Receive internal circuit error message via A/C switch assembly to LIN communication
Diagnosis delay time 30 second or more

POSSIBLE CAUSE

A/C switch assembly (internal circuit malfunction)

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

PERFORM SELF-DIAGNOSIS

CONSULT

  1. Ignition switch ON.

  2. Select “Self diagnosis result” mode of “HVAC”.

  3. Check DTC.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

PERFORM SELF DIAGNOSIS RESULT

CONSULT

  1. Ignition switch ON.

  2. Select “Self diagnosis result” mode of “HVAC”.

  3. Touch “ERASE”.

  4. Ignition switch OFF.

  5. Ignition switch ON.

  6. Perform “DTC CONFIRMATION PROCEDURE”. Refer to DTC Description.

Is DTC detected again?

YES>>

Replace A/C switch assembly. Refer to Removal and Installation.

NO>>

Inspection End.

    B24a4-11 Intake Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B24A4-11 INTAKE SENSOR (Intake sensor) Diagnosis condition I...
    B24c6-12 Blower Motor Control
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B24C6–12 BLOWER MOTOR CONTROL (Blower motor control) [CIRC...

    Other materials:

    Ivc Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). TCU 8CH CAN gateway Is the ...

    Preparation
    Commercial Service Tools Tool Description Power tool Loosening screws Sealant or/and Lubricant Name Description Primer (3M K500, K520 or equivalent) Primer for attaching sonar sensor holder to bumper ...

    Removal and Installation. Front Door
    Exploded View Front door panel Grommet Front door striker TORX bolt Clip Front outer pad Front door check link Front door hinge (lower) Front door hinge (upper) Front door weather-strip         : Clip : Alwa ...