Nissan Rogue (T33) 2021-Present Service Manual: B2205-29 Vehicle Speed
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detected condition | ||
|---|---|---|---|---|
| B2205-29 |
SPEED METER (Speed meter) |
Diagnosis condition | When ignition switch is ON. | |
| Signal (terminal) | Nissan Ariya Vehicle speed display signal | |||
| Threshold | An abnormal Nissan Ariya vehicle speed signal is input from ECM | |||
| Diagnosis delay time | 2 seconds or more | |||
POSSIBLE CAUSE
-
ECM
-
ABS actuator and electric unit (control unit)
-
Wheel sensor
FAIL-SAFE
Reset to zero of the speedometer by suspending communication.
DTC CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON and wait for 2 seconds or more.
-
Select “Self diagnosis result” mode of “M&A”.
-
Check DTC.
Is DTC B2205-29 detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer toIntermittent Incident .
NO-2>>Confirmation after repair: Inspection End.
Diagnosis Procedure
PERFORM SELF-DIAGNOSIS OF ECM
CONSULT
Select “Self diagnosis result” mode of “ECM.”
Is DTC detected?
YES>>Perform diagnosis procedure on the detected DTC. Refer to DTC Index.
NO>>GO TO 2.
PERFORM SELF-DIAGNOSIS OF ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
CONSULT
Select “Self diagnosis result” mode of “ABS.”
Is DTC detected?
YES>>Perform diagnosis procedure on the detected DTC. Refer to DTC Index.
NO>>Inspection End.
Other materials:
B2601-42 Memory Failure for Firmware Over the Air
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition
B2601-42
Memory failure for firmware over the air
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
—
Threshold
Errors are detected in the memory for software auto ...
Dtc/circuit Diagnosis. B2ccf-04 Passenger Door Mirror Control Module
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B2CCF-04
Passenger door mirror control module
(Passenger door mirror control module)
Diagnosis condition
Ignition switch is ON or OFF (auto ACC status).
Signal ...
Steering Switch Signal a Circuit
Component Function Check
CHECK COMBINATION METER INPUT SIGNAL
CONSULT
Ignition switch ON.
Select “Steering switch input” in “Data monitor” mode of “M&A”.
Check that the function operates normally according to the following conditions:
Condition Value
CONTRO ...