Nissan Rogue (T33) 2021-Present Service Manual: B2202-11 Fuel Sender

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Meter, Warning Lamp & Indicator / Type B :: Dtc/circuit Diagnosis / B2202-11 Fuel Sender

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content) 		DTC detected condition
B2202-11

Fuel level sensor

(Fuel level sensor) 		Diagnosis condition When ignition switch is ON.
Signal (terminal) Fuel level sensor signal
Threshold Short circuit
Diagnosis delay time —

POSSIBLE CAUSE

  • Fuel level sensor unit and fuel pump

  • Combination meter

  • Harness or connectors

FAIL-SAFE

Low fuel level warning displays

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON and wait for 1 minute or more.

  2. Select “Self diagnosis result” mode of “M&A”.

  3. Check DTC.

Is DTC B2202-11 detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer toIntermittent Incident .

NO-2>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK FUEL LEVEL SENSOR SIGNAL CIRCUIT

Check the fuel level sensor signal circuit. Refer to Component Function Check.

Is the inspection result normal?

YES>>

Replace combination meter. Refer to Removal and Installation.

NO>>

Repair or replace malfunctioning parts.

    Type B. Dtc/circuit Diagnosis
    B2205-29 Vehicle Speed
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detected condition B2205-29 SPEED METER (Speed meter) Diagnosis condition When i...

    Other materials:

    A-Bag Branch Line Circuit
    Diagnosis Procedure WARNING: Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait 3 minutes or more. (To discharge backup capacitor.) Never use unspecified tester or other measuring device. CHECK CONNECTOR Turn the ignition switch OFF. ...

    Removal and Installation. Front Power Window Switch Lh
    Removal and Installation CAUTION: Never bend the fixing pawl of power window switch finisher. REMOVALRemove power window switch finisher. Refer to Removal and Installation. Remove front power window switch (passenger side) from power window switch finisher . : Pawl INSTALLATIONInsta ...

    Manifold Absolute Pressure (map) Sensor
    Component Inspection CHECK MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR Turn ignition switch OFF. Remove manifold absolute pressure (MAP) sensor with its harness connector. Install pressure pump (A) to manifold absolute pressure (MAP) sensor. CAUTION: When insert a pressure pump hose ...