Nissan Rogue (T33) 2021-Present Service Manual: B220a-11 Combination Meter

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detected condition
B220A-11

Combination meter

(Combination meter)
Diagnosis condition When ignition switch is ON.
Signal (terminal) Illumination control signal
Threshold Short circuit
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

  • Combination meter

  • Harness or connectors

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON and wait for 2 seconds or more.

  2. Select “Self diagnosis result� mode of “M&A�.

  3. Check DTC.

Is DTC B220A-11 detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair:Inspection End.

Diagnosis Procedure

CHECK ILLUMINATION CONTROL SIGNAL CIRCUIT

  1. Disconnect harness connector of the combination meter Nissan Ariya vehicle side and all the connectors connected to illumination control signal circuit.

  2. Check harness continuity between combination meter harness connector and ground.

    Combination meter Ground Continuity
    Connector Terminal
    M76 1 No

Is the inspection result normal?

YES>>

Replace combination meter. Refer to Removal and Installation.

NO>>

Repair or replace malfunctioning parts.

    B2205-29 Vehicle Speed
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detected condition B2205-29 SPEED METER (Speed meter) Diagnosis condition When i...
    B2223-1c Combination Meter
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detected condition B2223-1C Combination meter (Combination meter) Diagnosis cond...

    Other materials:

    Kr15ddt. System Description. System
    System Warning/indicator (on Information Display) Low fuel warning DESIGN/PURPOSEThis warns the driver that the fuel level is low.OPERATION AT COMBINATION METER CAN COMMUNICATION CUT-OFF OR UNUSUAL SIGNALFor the operation for CAN communications blackout or abnormal signal reception, refer t ...

    P2123 App Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2123 00 APP SEN 1/CIRC (Throttle/Pedal position sensor/switch D circuit high) Diagnosis condition Engine running at idle Signal (terminal) Accelerator ...

    Symptom Diagnosis. Reverse Interlock Door Mirror Does Not Operate
    Diagnosis Procedure CHECK DTC Check DTC for Electric Shift control module. Refer to DTC Index. Is the inspection result normal? YES>> GO TO 2. NO>> Repair replace the malfunctioning parts. CHECK DTC Check DTC for BCM. Refer to DTC Index. Is the inspection result normal? YES& ...