Nissan Rogue (T33) 2021-Present Service Manual: B20c7-11 A/c Clutch

Nissan Rogue (T33) 2021-Present Service Manual / Ventilation, Heater & Air Conditioner :: Heater & Air Conditioning Control System / Automatic Air Conditioning :: Dtc/circuit Diagnosis / B20c7-11 A/c Clutch

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
B20C7–11

A/C clutch

(A/C clutch) 		[CIRCUIT SHORT TO GROUND] Diagnosis condition When A/C switch is ON
Signal (Terminal) Magnetic clutch ON signal
Threshold Magnetic clutch ON signal circuit has a shorted to ground
Diagnosis delay time 1 second or more

POSSIBLE CAUSE

  • Harness or connectors (magnetic clutch ON signal circuit is shorted to ground)

  • IPDM E/R

FAIL-SAFE

Inhibit A/C compressor (magnetic clutch) operation

DTC CONFIRMATION PROCEDURE

PERFORM SELF-DIAGNOSIS

CONSULT

  1. Start the engine.

  2. A/C switch ON.

  3. Select “Self diagnosis result” mode of “IPDM E/R”.

  4. Check DTC.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK MAGNETIC CLUTCH ON SIGNAL CIRCUIT FOR SHORT

  1. Ignition switch OFF.

  2. Disconnect IPDM E/R connector and A/C compressor connector.

  3. Check continuity between IPDM E/R harness connectors and the ground.

IPDM E/R — Continuity
Connector Terminal
F35 65 Ground No

Is the inspection result normal?

YES>>

Replace IPDM E/R. Refer to Removal and Installation.

NO>>

Repair harness or connector.

    Automatic Air Conditioning. Dtc/circuit Diagnosis
    B20c7-15 A/c Clutch
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B20C7–15 A/C clutch (A/C clutch) [CIRC SHORT TO BATT OR OP...

    Other materials:

    Removal and Installation. Spiral Cable
    Exploded View Combination switch Spiral cable Steering angle sensor : Pawl : Always replace after every disassembly. Removal and Installation WARNING: Always observe the following items for preventing accidental activation. Never use air tools or electric too ...

    Additional Service When Replacing Ecm
    Description When replacing ECM, the following procedure must be performed.CAUTION: When replacing the ECM, always replace it with a new one. The functions controlled by the ECM does not operate properly in case of reuse of the ECM from another Nissan Ariya vehicle. Work Procedure Work Proc ...

    System Description. Diagnosis System (bcm)
    Common Item CONSULT Function - COMMON ITEM BCM Refer to CONSULT Function (BCM - COMMON ITEM). Theft Alm CONSULT Function - THEFT ALM BCM Refer to CONSULT Function (BCM - THEFT ALM). ...