Nissan Rogue (T33) 2021-Present Service Manual: B20e2-96 Led Headlamp Rh

Nissan Rogue (T33) 2021-Present Service Manual / Driver Controls :: Exterior Lighting System / Led Headlamp :: Dtc/circuit Diagnosis / B20e2-96 Led Headlamp Rh

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC detection condition
B20E2–96

LED HEADLAMP RH

(Light emitting diode headlamp right hand) 		[CMPNENT INTERNAL MLFNCTN] Diagnosis condition Ignition switch ON
Signal (terminal) Headlamp warning signal (via LIN communication)
Threshold Detected a malfunction of headlamp RH (LO) circuit
Diagnosis delay time 1 second or less

POSSIBLE CAUSE

  • Front combination lamp RH

    • LED [headlamp (LO)]

    • LED headlamp control module

FAIL-SAFE

  • Transmits the headlamp warning signal (CAN communication) to the combination meter (when the ignition switch is placed ON, the headlamp warning is displayed on the information display of the combination meter).

  • Transmits the request signal to the both side LED headlamp control module via LIN communication, and turns ON the headlamp (LO) and parking lamp.

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self diagnosis result” mode of “IPDM E/R”.

  3. Check DTC.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

REPLACE HEADLAMP RH

Replace front combination lamp RH. Refer to Removal and Installation.

>>

Inspection End.

    B20d4-11 Tail Lamp Lh Pwr Sply Circ
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B20D4–11 TAIL LAMP LH PWR SPLY CIRC (Tail lamp left hand p...
    B2c96-49 Light Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B2C96-49 Light sensor (Light sensor) Diagnosis condition Whe...

    Other materials:

    Vdc Off Indicator Lamp
    Component Function Check CHECK VDC OFF INDICATOR LAMP FUNCTION (1) Check that VDC OFF indicator lamp in combination meter turns ON for approximately 1 second after ignition switch is ON. CAUTION: Never start engine. Is the inspection result normal? YES>> GO TO 2. NO>> Refer ...

    Abs Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). ABS actuator and electric unit (control u ...

    P052a Intake Valve Timing Control
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P052A 00 CAMSHAFT POSITION TIMING B1 (Cold start “A” camshaft position timing over-advanced bank 1) Diagnosis condition Cold condition Signal (terminal) ...