Nissan Rogue Owners Manual: Audio system
- Radio
- FM radio reception
- AM radio reception
- Satellite radio reception (if so equipped)
- Audio operation precautions
- FM/AM radio with compact disc (CD) player (if so equipped)
- FM/AM/SAT radio with compact disc (CD) player (Type A) (if so equipped)
- FM/AM/SAT radio with compact disc (CD) player (Type B) (if so equipped)
- USB (Universal Serial Bus) Connection Port (models without Navigation System) (if so equipped)
- USB (Universal Serial Bus) Connection Port (models with Navigation System) (if so equipped)
- iPod®* player operation without Navigation System (if so equipped)
- iPod®* player operation with Navigation System (if so equipped)
- Bluetooth® streaming audio without Navigation System (if so equipped)
- Bluetooth® streaming audio with Navigation System
- CD care and cleaning
- Steering wheel switch for audio control
Servicing air conditioner
The air conditioner system in your NISSAN vehicle
is charged with a refrigerant designed with
the environment in mind.
This refrigerant does not harm the earth’s
ozone layer.
Special charging ...
Radio
With the ignition placed in the ACC or ON position,
press the or POWER
button/VOLUME control knob to turn the radio
on. If you listen to the radio with the engine not
running, the ignition should ...
Other materials:
Front wiper motor ground circuit
Diagnosis Procedure
Regarding Wiring Diagram information, refer to WW-22, "Wiring Diagram".
1. CHECK FRONT WIPER MOTOR GROUND CIRCUIT
Turn the ignition switch OFF.
Disconnect front wiper motor.
Check continuity between front wiper motor harness connector and
...
Sensor maintenance
Sensor maintenance
The distance sensor for the FCW system A is
located behind the front bumper.
To keep the FCW system operating properly, be
sure to observe the following:
Always keep the sensor area of the front
bumper clean.
Do not strike or damage the areas around
...
Roof side molding
Exploded View
Roof side molding
Back door hinge cover
Metal clip
Pawl
Removal and Installation
REMOVAL
Release roof side molding (1) using suitable tool (A) then
remove roof side molding.
: Metal clip
CAUTION:
Apply protective tape (B) around the roof side moldi ...
