Nissan Rogue (T33) 2021-Present Service Manual: 2wd :: Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting

Nissan Rogue (T33) 2021-Present Service Manual / Transmission & Driveline :: Rear Axle / 2wd :: Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting

Noise, Vibration and Harshness (nvh) Troubleshooting

NVH Troubleshooting Chart

Use chart below to find the cause of the symptom. If necessary, repair or replace these parts.

Possible cause and SUSPECTED PARTS Symptom Reference
REAR AXLE
Noise Shake Vibration Shimmy Judder Poor quality ride or handling
Improper installation, looseness × × × × × × Exploded View
Parts interference × × × × — × —
Wheel bearing damage × × × — — — Inspection
Rear axle and rear suspension × × × × × ×

  • Refer to REAR AXLE in this chart

  • REAR SUSPENSION: NVH Troubleshooting Chart
Tire × × × × × × NVH Troubleshooting Chart
Road wheel × × — × × × NVH Troubleshooting Chart
Brake × × — × × — NVH Troubleshooting Chart

×: Applicable, —: Not applicable

    2wd. Preparation. Preparation
    Preparation Commercial Service Tools Tool name Description Ball joint remover Removing hub bolt Always Replace with New Parts Never Reuse These Parts Part CodeFor additional inf...
    2wd. Periodic Maintenance. Rear Wheel Hub and Housing
    Rear Wheel Hub and Housing Inspection COMPONENT PARTMake sure that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are no...

    Other materials:

    Dtc/circuit Diagnosis. U2148-87 Can Comm Err (brake Control Unit)
    DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan Ariya vehicle is equipped ...

    Rear Final Drive: R145. Unit Removal and Installation. Rear Final Drive Assembly
    Rear Final Drive Assembly Exploded View Final drive mounting bracket Mounting stopper Rear final drive assembly : N·m (kg-m, ft-lb) : Always replace after every disassembly. Removal and Installation REMOVALNOTE: When replacing AWD control unit (integrated with act ...

    U0076-00 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition U0076 00 Control module communication Bus D Off Diagnosis condition When ignition switch is ON. Signal (terminal) CAN communication signal Threshold Not transmitting. Diagn ...