Nissan Rogue (T33) 2021-Present Service Manual: 2wd :: Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting

Nissan Rogue (T33) 2021-Present Service Manual / Transmission & Driveline :: Front Axle / 2wd :: Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting

Noise, Vibration and Harshness (nvh) Troubleshooting

NVH Troubleshooting Chart

Use chart below to find the cause of the symptom. If necessary, repair or replace these parts.

Possible cause and SUSPECTED PARTS Symptom Reference
DRIVE SHAFT FRONT AXLE
Noise Shake Noise Shake Vibration Shimmy Judder Poor quality ride or handling
Excessive joint angle × × — — — — — — —
Joint sliding resistance × — — — — — — — Inspection
Imbalance — × — — — — — — —
Improper installation, looseness — — × × × × × × Exploded View
Parts interference — — × × × × — × —
Wheel bearing damage × × × × × — — — Inspection
Front axle and Front suspension × × × × × × × ×

  • Refer to FRONT AXLE in this chart

  • FRONT SUSPENSION: NVH Troubleshooting Chart
Front axle × × — — — — — — Refer to FRONT AXLE in this chart
TIRE × × × × × × × × NVH Troubleshooting Chart
Road wheel × × × × — × × × NVH Troubleshooting Chart
Drive shaft — — × × × — — — Refer to DRIVE SHAFT in this chart
Brake × × × × — × × — NVH Troubleshooting Chart
Steering × × × × × × × — NVH Troubleshooting Chart
Improper Lubrication of hub bearing surface causing clicking noise — — — — — — — — Inspection

×: Applicable, —: Not applicable

    2wd. Preparation. Preparation
    Preparation Special Service Tool Tool number (TechMate No.) Tool name Description KV40104000 ( – ) Hub lock nut wrench a: 85 mm (3.35 in) b: 65 mm (2.56 in) Removing and Insta...
    2wd. Periodic Maintenance
    Front Wheel Hub and Knuckle Inspection COMPONENT PARTMake sure that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are n...

    Other materials:

    C10b2-01 Parking Brake Switch
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C10B2 01 Parking brake switch (Parking brake switch) Diagnosis condition When ignition switch is ON Signal (terminal) Paring brake switch Threshold ...

    P0443 Evap Canister Purge Volume Control Solenoid Valve
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0443 00 PURG VOLUME CONT/V (EVAP system purge control valve "A" circuit) A Diagnosis condition Engine cold start Signal (terminal) — Thresho ...

    Calibration of Decel G Sensor
    Description CAUTION: Always perform the decel G sensor calibration before driving when the following operation is performed. Refer to Work Procedure. ×: Required —: Not required Procedure Decel G sensor calibration Removing/ installing ABS actuator and electric unit (control unit) × ...