Nissan Rogue (T33) 2021-Present Service Manual: 2wd :: Periodic Maintenance
Front Wheel Hub and Knuckle
Inspection
COMPONENT PART
Make sure that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal.
WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE)
Check the following items, and replace the part if necessary.
-
Move wheel hub and bearing assembly in the axial direction by hand. Check there is no looseness of wheel bearing.
Axial end play : Refer to Wheel Bearing. -
Rotate wheel hub and make sure there is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub and bearing assembly.
Front Drive Shaft
Inspection
FRONT DRIVE SHAFT INSPECTION
Check the following items, and replace the part if necessary.
-
Check drive shaft mounting point and joint for looseness and other damage.
CAUTION:
Replace entire drive shaft assembly when noise or vibration occur from drive shaft.
-
Check boot for cracks and other damage.
Other materials:
Tire labeling
Example
Basic information
Federal regulations require tire manufacturers to display standardized identification information on the sidewall of every tire. These markings describe essential tire characteristics and include the Tire Identification Number (TIN), which is used for recall tracking ...
B2721-81 Center Sensor [rl]
DTC Description
DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition
B2721-81
CENTER SENSOR [RL]
Center sensor [RL]
Diagnosis condition
When ignition switch is ON
Signal (terminal)
Rear sonar sensor signal LH inner
Threshold
...
Precaution. Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT
PRE-TENSIONER”, used along with a front seat belt, helps to reduce the
risk or severity of injury to the driver and front passeng ...
