Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Warning/indicator lights (other)
Automatic brake hold indicator light (white)
The automatic brake hold indicator light (white) illuminates when the automatic brake hold system in the Nissan Rogue is on standby.
Automatic brake hold indicator light (green)
The automatic brake hold indicator light (green) illuminates when the automatic brake hold system is actively operating on your Nissan Rogue.
Exterior light indicator
This indicator illuminates when the headlight switch is turned to the AUTO,
or
position, meaning the exterior lighting systems of the Nissan Rogue—such as front parking lights, rear combination lights, license plate lights, or headlights—are turned on. The indicator turns off when these lights are switched off.
High beam assist indicator light
The high beam assist indicator light illuminates when the high beam assist system is turned on and functioning.
High beam indicator light
This light illuminates when the headlight high beams are on and turns off when low beams are selected.
Turn signal/hazard indicator lights
The indicator flashes when the turn signal lever or hazard switch is activated.
Audible reminders
Light reminder chime
The light reminder chime will sound when the headlight switch is in the
or
position after the engine is turned off and the driver's door is opened while the exterior lights remain on. Turn the switch to OFF or AUTO before leaving the Nissan Rogue.
Driving Aid chimes (if so equipped)
An audible alert may sound if any of the following systems are active:
- Lane Departure Warning (LDW)*
- Intelligent Lane Intervention (I-LI)*
- Blind Spot Warning (BSW)
- Intelligent Blind Spot Intervention (IBSI)
- Rear Cross Traffic Alert (RCTA)
- ProPILOT Assist
- Automatic Emergency Braking (AEB) with Pedestrian Detection
- Intelligent Forward Collision Warning (I-FCW)
- Intelligent Driver Alertness (I-DA)
- Rear Automatic Braking (RAB)
- Sonar system
- Rear Sonar System (RSS)
*Only when Steering Assist (if equipped) is turned on.
For more information, refer to the "5. Starting and driving" section of this manual.
Door lock warning chime
When the warning chime sounds, verify both the vehicle and the Intelligent Key.
Brake pad wear warning
The disc brake pads include audible wear indicators. When replacement is needed, a high-pitched scraping sound may be heard when the Nissan Rogue is in motion. Initially the sound occurs only during braking; with further wear, it may be heard even without pressing the brake pedal. Have the brakes inspected promptly if this warning sound is heard.
Other materials:
System
Meter System
System Description
SYSTEM DIAGRAM Parts name Description
Ambient sensor
Refer to Ambient Sensor.
BCM
Transmits the BCM status to the combination meter via CAN communication.
Combination meter
Refer to Combination Meter.
ECM
Transmits the ECM status to ...
P1a10 Ecm Initial Learning Incomplete
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P1A10
00
ECM initial learning Incomplete
(ECM initial learning Incomplete)
Diagnosis condition
Ignition switch ON
Signal (terminal)
—
Threshold ...
Hood
WARNING
Make sure the hood of your Nissan Rogue is fully closed and latched before driving.
Do not open the hood if steam or smoke is coming from the engine compartment.
1. Pull the hood lock release handle 1 located below the driver’s side instrument panel
to slightly raise the hood of t ...
