Nissan Rogue (T33) 2021-Present Service Manual: Variable Compression Ratio Motor Rotation Angle Sensor
Component Inspection
CHECK VCR MOTOR ROTATION ANGLE SENSOR
-
Turn ignition switch OFF.
-
Disconnect VCR motor rotation angle sensor harness connector.
-
Check the continuity between VCR motor rotation angle sensor harness connectors.
VCR motor rotation angle sensor Continuity Terminal 5 6 Existed 3 4 1 2 -
Check harness for short to power and short to ground.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Replace VCR actuator. Refer to Removal and Installation.
Other materials:
U0073-00 Control Module Comm Bus a Off
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U0073
00
Control module comm Bus A Off
(Control module communication Bus A Off)
1
Diagnosis condition
When ignition switch is ON.
When the power sup ...
C1f03-72 Stop Lamp Relay
Without Propilot Assist 2.1
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1F03
72
OPERATION SW CIRC
(Operation switch circuit)
Diagnosis condition
When engine is running
When AEB system is ...
P2a01 Ho2s2
DTC Description
The heated oxygen sensor 2 has a much longer switching time between
rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage
capacity of the three way catalyst (manifold) causes the longer
switching time.MALFUNCTION ATo judge the malfunctions of
heated oxygen ...
