Nissan Rogue (T33) 2021-Present Service Manual: Variable Compression Ratio Motor

Component Inspection

CHECK VCR MOTOR

  1. Turn ignition switch OFF.

  2. Disconnect VCR motor harness connector.

  3. Check the continuity between VCR motor terminals as per the following.

    VCR motor Continuity
    Terminal
    2 3 Existed
    1
    3 1
  4. Check harness for short to power and short to ground.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace VCR actuator. Refer to Exploded View.

    Variable Compression Ratio Control Shaft 2 Rotation Angle Sensor
    Component Inspection CHECK VCR CONTROL SHAFT 2 ROTATION ANGLE SENSOR Turn ignition switch OFF. Disconnect VCR control shaft 2 rotation angle sensor harness connector. Check the ...
    Variable Compression Ratio Motor Rotation Angle Sensor
    Component Inspection CHECK VCR MOTOR ROTATION ANGLE SENSOR Turn ignition switch OFF. Disconnect VCR motor rotation angle sensor harness connector. Check the continuity between V...

    Other materials:

    System Description. System
    Tire Pressure Monitoring System System Description During driving, the TPMS (tire pressure monitoring system) system receives the signal transmitted from the tire pressure sensor installed in each wheel. The BCM has pressure judgment and trouble diagnosis functions. When the TPMS system ...

    U0079-00 Can Comm Circuit
    DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real-time application. It is an onNissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equippe ...

    P050a Cold Start Control
    DTC Description DESCRIPTIONECM controls ignition timing and engine idle speed when engine is started with pre-warming up condition.This control promotes the activation of three way catalyst by heating the catalyst and reduces emissions.DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diag ...