Nissan Rogue (T33) 2021-Present Service Manual: Variable Compression Ratio Control Shaft 2 Rotation Angle Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / Variable Compression Ratio Control Shaft 2 Rotation Angle Sensor

Component Inspection

CHECK VCR CONTROL SHAFT 2 ROTATION ANGLE SENSOR

  1. Turn ignition switch OFF.

  2. Disconnect VCR control shaft 2 rotation angle sensor harness connector.

  3. Check the continuity between VCR control shaft 2 rotation angle sensor harness connectors.

    VCR control shaft 2 rotation angle sensor Continuity
    Terminal
    1 2 Existed
    3 4
    5 6

  4. Check harness for short to power and short to ground.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace VCR actuator. Refer to Removal and Installation.

    Turbocharger Bypass Control Valve
    Component Inspection CHECK TURBOCHARGER BYPASS CONTROL VALVE With consult Turn ignition switch ON and engine stopped or engine running (idling, less than 1200rpm). On the CONSUL...
    Variable Compression Ratio Motor
    Component Inspection CHECK VCR MOTOR Turn ignition switch OFF. Disconnect VCR motor harness connector. Check the continuity between VCR motor terminals as per the following. VCR...

    Other materials:

    P00f2 Maf Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P00F2 00 Humidity Sensor Circuit/Open (Humidity Sensor Circuit/Open) Diagnosis condition — Signal (terminal) Humidity sensor　signal Threshold ...

    System Description. Component Parts. Drive Mode System
    Drive Mode System Component Parts Location No. Component Function 1. Drive mode select switch Refer to Drive Mode Select Switch. 2. Chassis control module Chassis control module controls the drive mode select system. Refer to Component Parts Location (without ProPILOT Assi ...

    Basic Inspection. Calibration of Automatic Back Door Position Information
    Description When the following work is performed, it is necessary to perform initial setting of automatic back door position information to operate automatic back door system. Refer to Work Procedure. After removing and installing, or replacing automatic back door control unit After rem ...