Nissan Rogue (T33) 2021-Present Service Manual: Turbocharger Bypass Control Valve

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / Turbocharger Bypass Control Valve

Component Inspection

CHECK TURBOCHARGER BYPASS CONTROL VALVE

With consult

  1. Turn ignition switch ON and engine stopped or engine running (idling, less than 1200rpm).

  2. On the CONSULT screen, select ENGINE » ACTIVE TEST »“Turbocharger bypass valve”.

  3. Operate “ON” or “OFF” and check if valve operating sound can be heard.

Without consult

  1. Turn ignition switch OFF.

  2. Disconnect turbocharger bypass control valve harness connector.

  3. Apply a voltage of 12V to the positive or negative terminal.

Can the valve operating sound be heard?

YES>>

INSPECTION END

NO>>

Replace turbocharger assembly (do not replace bypass control valve only). Refer to Exploded View.

    Turbocharger Boost Sensor
    Component Inspection CHECK TURBOCHARGER BOOST SENSOR Turn ignition switch OFF. Remove turbocharger boost sensor with its harness connector. Install pressure pump (A) to turbocha...
    Variable Compression Ratio Control Shaft 2 Rotation Angle Sensor
    Component Inspection CHECK VCR CONTROL SHAFT 2 ROTATION ANGLE SENSOR Turn ignition switch OFF. Disconnect VCR control shaft 2 rotation angle sensor harness connector. Check the ...

    Other materials:

    Interior lights
    Basic information CAUTION Do not leave the interior light switch on when the engine of your Nissan Rogue is not running for extended periods of time, as this can discharge the battery. Always turn off the lights when leaving the vehicle. Interior light switch The interior light can be turn ...

    B261e-56 Pairing Error
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition B261E-56 Pairing error Diagnosis condition When ignition switch is ON. Signal (terminal) — Threshold HFM pairing not performed Diagnosis delay time 10 seconds or more ...

    Crankcase Pressure Sensor
    Diagnosis Procedure CHECK CRANKCASE PRESSURE SENSOR POWER SUPPLY Turn ignition switch OFF. Disconnect crankcase pressure sensor connector. Turn ignition switch ON. Check the voltage between crankcase pressure sensor harness connector terminals. + − Voltage (Approx.) C ...