Nissan Rogue (T33) 2021-Present Service Manual: U2176-87 Can Comm Err (ccm/st Angle Sensor)

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Power Control System / Ipdm E/r :: Dtc/circuit Diagnosis / U2176-87 Can Comm Err (ccm/st Angle Sensor)

DTC Description

CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan Ariya vehicle is equipped with many electronic control unit, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-High line, CAN-Low line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only.

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC detection condition
U2176-87

CAN comm err (CCM/ST angle sensor)

[Controller area network communication error (chassis control module/steering angle sensor)] 		[MISSING MESSAGE] Diagnosis condition When ignition switch is ON
Signal (terminal) CAN communication signal
Threshold When IPDM E/R cannot communicate CAN communication signal
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON and wait for 2 seconds or more.

  2. Select “Self diagnosis result” mode of “IPDM E/R”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK CAN COMMUNICATION SYSTEM

Perform trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.

>>

Inspection End.

    U2159-87 Can Comm Err (steering Control Unit)
    DTC Description CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line with high ...
    Power Supply and Ground Circuit
    Diagnosis Procedure CHECK FUSIBLE LINK Ignition switch OFF. Check that the following fusible links are not blown (open): Signal name Fusible link No. Capacity Battery power supp...

    Other materials:

    Dtc/circuit Diagnosis. B1002-13 Lap Pre-Tensioner Rh
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B1002-13 Lap pre-tensioner RH (Lap pre-tensioner right hand) Diagnosis condition When ignition switch is ON. Signal (terminal) Lap pre-tensioner RH signal ...

    P14a5 Charge Air Cooler Cooling Electric Water Pump
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P14A5 Charge air cooler coolant pump (Charge air cooler coolant pump control circuit high) Diagnosis condition Engine running at idle Warm-up condition ...

    Power Supply and Ground Circuit
    Ecm Diagnosis Procedure CHECK THE BATTERY CABLE Turn ignition switch OFF. Check the battery cable for tightening enough. NOTE: Check the continuity between the battery cable and the battery terminal. Is the inspection result normal? YES>> GO TO 2 ...