Nissan Rogue (T33) 2021-Present Service Manual: Power Supply and Ground Circuit
Diagnosis Procedure
CHECK FUSIBLE LINK
-
Ignition switch OFF.
-
Check that the following fusible links are not blown (open):
Signal name Fusible link No. Capacity Battery power supply E 100A D 100A B 140A Z 30A
Is the fusible link blown (open)?
YES>>Replace the blown (open) fusible link after repairing the affected circuit if a fusible link is blown (open).
NO>>GO TO 2.
CHECK BATTERY POWER SUPPLY CIRCUIT
-
Disconnect IPDM E/R connector.
-
Check voltage between IPDM E/R harness connector and ground.
+ - Voltage IPDM E/R Connector Terminal E118 1 Ground Battery voltage 2 F41 81
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair the harness or connector.
CHECK GROUND CIRCUIT
Check continuity between IPDM E/R harness connectors and ground.
| IPDM E/R | — | Continuity | |
|---|---|---|---|
| Connector | Terminal | ||
| E119 | 12 | Ground | Yes |
| E120 | 31 | ||
| E121 | 47 | ||
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair the harness or connector.
Other materials:
Removal and Installation. Back Door
Exploded View
Roof seal
Back door weather-strip
Back door hinge LH
Back door stay LH*
Stud ball
Back door bumper rubber upper
Back door bumper rubber lower
Back door striker
TORX bolt
Back door panel
Back door stay RH*
Back door hinge RH ...
P0327 Ks
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0327
00
KNOCK SEN/CIRC-B1
(Knock/combustion vibration sensor 1 circuit low bank 1 or single sensor )
Diagnosis condition
Engine running at idle
Signal (t ...
U2252 Can Comm Circuit
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
U2252
83
CAN comm err (ADAS control unit)
[CAN comm err (ADAS control unit)]
Diagnosis condition
Ignition switch ON
Signal (terminal)
CAN communication ...
