Nissan Rogue (T33) 2021-Present Service Manual: U1ca2-08 Lin Communication 3
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| U1CA2-08 |
LIN communication 3 (Local interconnect network communication 3) |
Diagnosis condition | Ignition switch ON |
| Signal (Terminal) | LIN (door motor) signal | ||
| Threshold | A/C amp. is not transmitting or receiving LIN communication with each door motor | ||
| Diagnosis delay time | 2 second or more | ||
POSSIBLE CAUSE
-
Harness and connector (door motor circuit is open or shorted to ground)
-
Each door motor
-
A/C amp.
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Start the engine.
-
Select "Self diagnosis result" mode of "HVAC".
-
Check DTC.
Is DTC detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
Diagnosis Procedure
CHECK DTC
CONSULT
-
Start the engine.
-
Select "Self diagnosis result" mode of "HVAC".
-
Check following DTC.
DTC Items
(CONSULT screen terms)Reference U1CAA-02 Mode door motor DTC Description U1CAB-02 Intake door motor DTC Description U1CAD-02 Air mix door motor 2 DTC Description
Is DTC detected?
YES>>Perform DTC diagnosis procedure that is detecting.
NO>>Replace A/C amp. Refer to Removal and Installation.
Other materials:
Dtc/circuit Diagnosis. B2428-46 Automatic Back Door Control Unit
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC Detection Condition
B2428-46
Automatic back door control unit
(Automatic back door control unit)
Diagnosis condition
All times
Signal (terminal)
—
Threshold
Automatic ...
Electric Wastegate Control Actuator
Component Inspection
INSPECTION START
Do you have CONSULT?
Do you have CONSULT?
YES>>
GO TO 2.
NO>>
GO TO 3.
CHECK ELECTRIC WASTEGATE CONTROL ACTUATOR
With CONSULT
Turn ignition switch ON and engine stopped.
On the CONSULT screen, select “ENGINE”>>“ACTIVE ...
Symptom Diagnosis. Intelligent Key Low Battery Warning Does Not Operate
Diagnosis Procedure
CHECK INFORMATION DISPLAY
Check information display.
Refer to Work flow.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CHECK INTELLIGENT KEY BATTERY
Check Intelligent Key battery.
Refer to Component Inspe ...
