Nissan Rogue (T33) 2021-Present Service Manual: U1327-54 Mac Key
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| U1327-54 |
MAC key update (Message Authentication Code key update) |
Diagnosis condition | - |
| Signal (terminal) | - | ||
| Threshold | MAC key is not written after sonar control unit replacement. | ||
| Diagnosis delay time | - | ||
POSSIBLE CAUSE
-
Writing of MAC key has not been executed
-
Sonar control unit
FAIL-SAFE
-
DTC CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Ignition switch ON.
-
Perform “MAC Diagnosis” of “SONAR” using CONSULT.
Is DTC U1327-54 detected as the current malfunction?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
PERFORM MAC KEY WRITING
With CONSULT
-
Perform “MAC key writing”. Refer to Description.
-
Perform “MAC Diagnosis” of “SONAR” using CONSULT.
Is DTC U1327-54 detected as the current malfunction?
YES>>GO TO 2.
NO>>INSPECTION END
PERFORM MAC KEY WRITING AGAIN (SECOND TIMES)
With CONSULT
-
Restart CONSULT.
-
Perform “MAC Key writing” again. Refer to Description.
-
Perform “MAC Diagnosis” of “SONAR” using CONSULT.
Is DTC U1327-54 detected as the current malfunction?
YES>>GO TO 3.
NO>>INSPECTION END
PERFORM MAC KEY WRITING AGAIN (THIRD TIMES)
With CONSULT
-
Restart CONSULT.
-
Perform “MAC Key writing” again. Refer to Description.
-
Perform “MAC Diagnosis” of “SONAR” using CONSULT.
Is DTC U1327-54 detected as the current malfunction?
YES>>Replace sonar control unit. Refer to Removal and Installation.
NO>>INSPECTION END
Other materials:
Oil Level Sensor Signal Circuit
DiagnosisProcedure
CHECK OIL LEVEL SENSOR CIRCUIT
Ignition switch OFF.
Disconnect combination meter harness connector and oil level sensor harness connector.
Check continuity between combination meter harness connector and oil level sensor harness connector.
Combination meter
Oi ...
Basic Inspection. Tire Pressure Sensor Id Registration
Description
This procedure must be performed.
After replacement of a tire pressure sensor or BCM.
After replacement of tire or road wheel.
NOTE:
ID registration is unnecessary if there are no change in
the positions of each wheels (tire pressure sensors) before wheel
removal and after ...
Dtc/circuit Diagnosis. Interior Room Lamp Power Supply Circuit
Diagnosis Procedure
Provides the interior room lamp power supply. Also cuts the power
supply when the interior room lamp battery saver is activating.CHECK INTERIOR ROOM LAMP POWER SUPPLY FUSE
Ignition switch OFF.
Check that the following fuse is not blown (open):
Signal name Location ...
