Nissan Rogue (T33) 2021-Present Service Manual: U0469 Can Communication

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / U0469 Can Communication

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
U0469 00

Invalid data (starter/generator C/U)

(Invalid Data Received From Starter / Generator Control Module) 		Diagnosis condition Ignition switch ON
Signal (terminal) —
Threshold When ECM is not transmitting or receiving invalid CAN data signal of OBD (emission-related diagnosis) with with Sub-starter & generator C/U.
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

  • Harness or connectors (CAN communication line is open or shorted.)

  • Sub starter & generator C/U

  • USM

FAIL-SAFE

Engine Control System

Not applicable

Stop/Start System

When a DTC is detected, the stop/start indicator lamp blinks slowly and the stop/start system operation is prohibited. When ECM detects error while operating the stop/start system, ECM restarts the engine.

DTC Confirmation Procedure

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

>>

2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON and wait at least 10 seconds.

  2. Check DTC.

Is DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

Perform trouble diagnosis of CAN communication system. Refer to Trouble Diagnosis Flow Chart.

    U0431 Can Communication
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0431 00 Invalid data (BCM A) (Invalid Data Received From Body C...
    U060f Sent Communication
    DTC Description DTC DETECTION LOGICWhen ECM unable to transmit engine communication signal. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U060F 00...

    Other materials:

    Turbocharger Wastegate Control Solenoid Valve Data Initialization
    Description ECM learns a turbocharger wastegate valve position at every engine start to perform more accurate boost control.Learning value of turbocharger wastegate valve position must be initialized where the following operations are performed: Replacement of turbocharger Replacement of EC ...

    P2a01 Ho2s2
    DTC Description The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold) causes the longer switching time.MALFUNCTION ATo judge the malfunctions of heated oxygen ...

    Front Oil Seal
    Removal and Installation REMOVALRemove the drive belt. Refer to Removal and Installation. Remove the fender protector. Refer to Removal and Installation. Remove crankshaft pulley using the following procedure:Loosen crankshaft pulley bolt. CAUTION: Do not remove the crankshaft pulley bolt as it ...