Nissan Rogue (T33) 2021-Present Service Manual: U0155 Can Communication (combination Meter)

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / U0155 Can Communication (combination Meter)

DTC Description

CAN (Controller Area Network) is a serial communication line for real time application. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent malfunction detection ability. Many electronic control units are equipped onto a Nissan Ariya vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control unit is connected with 2 communication lines (CAN-H and CAN-L) allowing a high rate of information transmission with less wiring. Each control unit communicates data but selectively reads required data only.

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detecting condition
U0155 　 00 　

LOST COMM (METER)

Lost communication with instrument panel cluster (IPC) control module 		Diagnosis condition —
Signal (terminal) —
Threshold A DTC is set if ECM cannot receive the CAN communication signals from combination meter for 2 seconds or more.
Diagnosis delay time —

POSSIBLE CAUSE

Harness or connectors

(CAN communication line is open or shorted.)

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

PRECONDITIONING

If another “DTC CONFIRMATION PROCEDURE” is performed just before the next test, turn the ignition switch OFF and wait for 10 seconds or more, then perform the next test.

>>

GO TO 2.

CHECK DTC DETECTION

With CONSULT

  1. Start the engine and wait for 2 seconds or more.

  2. Check “Self Diagnostic Result” of “ENGINE”.

Is DTC U0155 detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK CAN COMMUNICATION CIRCUIT

Refer to Trouble Diagnosis Flow Chart.

Is the inspection result normal?

YES>>

Refer to Intermittent Incident.

NO>>

Repair or replace damaged parts.

    U0146 Can Communication
    DTC Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-Nissan Ariya vehicle multiplex communication line with high d...
    U0164 Can Communication
    DTC Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-Nissan Ariya vehicle multiplex communication line with high d...

    Other materials:

    Dtc/circuit Diagnosis. Memory Indicator
    Component Function Check CHECK FUNCTION Push set switch. Check memory indicator operation. When driver seat position is already retained in memory : Illuminated for 5 seconds When driver seat position is not retained in memory : Illuminated for 0.5 second Is the ins ...

    Propilot Assist 2.1. Ecu Diagnosis Information
    Adas Control Unit 2 List of ECU Reference ECU Reference ADAS control unit 2 Reference Value Fail-safe (ADAS Control Unit) DTC Inspection Priority Chart DTC Index Distance Sensor List of ECU Reference ECU Reference Distance sensor Reference Value Fail-safe ...

    Symptom Diagnosis. Squeak and Rattle Trouble Diagnoses
    Work Flow CUSTOMER INTERVIEWInterview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any of customer's comments. Refer to Diagnostic Work ...