Nissan Rogue (T33) 2021-Present Service Manual: U0101 Can Comm Circuit
DTC Description
DESCRIPTION
CAN (Controller Area Network) is a serial communication line for real time application. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a Nissan Ariya vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only.
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| U0101 | 00 |
LOST COMM (TCM) (Lost Communication with TCM) |
Diagnosis condition | Ignition switch ON |
| Signal (terminal) | CAN communication signal | |||
| Threshold | ECM is not receiving CAN communication signal of OBD (emission-related diagnosis) with TCM | |||
| Diagnosis delay time | 2 seconds or more | |||
POSSIBLE CAUSE
Harness or connectors (CAN communication line is open or shorted)
FAIL-SAFE
Engine Control System
Not applicable
Stop/Start System
When a DTC is detected, the stop/start indicator lamp blinks slowly and the stop/start system operation is prohibited.
When ECM detects error while operating the stop/start system, ECM restarts the engine.
DTC Confirmation Procedure
PERFORM DTC CONFIRMATION PROCEDURE
-
Turn ignition switch ON and wait at least 3 seconds.
-
Check DTC.
Is DTC detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.
Other materials:
Dtc/circuit Diagnosis. Lin Communication Circuit
Moonroof Motor Assembly
Diagnosis Procedure
CHECK LIN COMMUNICATION SIGNAL
Ignition switch OFF.
Disconnect moonroof motor assembly harness connector.
Ignition switch ON.
Check signal between moonroof motor assembly harness connector and ground using an oscilloscope.
(+) (— ...
Conventional (fixed speed) cruise control
Basic information
Conventional (fixed speed) cruise control is available as an alternative to Intelligent Cruise Control. To activate the conventional cruise control mode in the Nissan Rogue:
Example
1. Push and hold the ProPILOT Assist switch A for longer than approximately 1.5 seconds.
2. Once ...
Removal and Installation. Back Door Opener Switch
Removal and Installation
REMOVAL
Remove back door inner finisher. Refer to Removal and Installation.
Disconnect back door opener switch connector.
Remove back door opener switch grommet using removal tool.
Remove back door opener switch fixing pawls using removal tool (A), and ...
