Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Parking Brake Does Not Operate

Nissan Rogue (T33) 2021-Present Service Manual / Brakes :: Parking Brake System / Symptom Diagnosis :: Parking Brake Does Not Operate

Description

The parking brake is not applied even when the parking brake switch is pulled.

Diagnosis Procedure

PERFORM THE SELF DIAGNOSIS RESULT

CONSULT

Select "Self diagnosis result" mode of "ABS".

Is DTC detected?

YES>>

Check the DTC. Refer to DTC Index.

NO>>

GO TO 2.

CHECK PARKING BRAKE ACTUATOR

Pull or push parking brake switch, check operation sound of parking brake actuator.

Is the inspection result normal?

YES>>

Inspection End

NO>>

GO TO 3.

CHECK REAR DISC BRAKE SYSTEM

Check the rear disc brake system. Refer to Inspection and Adjustment.

Is the inspection result normal?

YES>>

Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.

NO>>

Repair or replace the rear disc brake system. Refer to Removal and Installation.

    Symptom Diagnosis. Parking Brake Does Not Release
    Description When the parking brake cannot be released by the parking brake switch.CAUTION: Never reuse the parking brake actuator. When replacing parking brake actuator, replace...
    Symptom Diagnosis. The Braking Force of Parking Brake Is Low
    Description The parking brake braking force is low and the vehicle moves backward when parked on an incline. Diagnosis Procedure REAPPLY THE PARKING BRAKE (1) Pull the parking b...

    Other materials:

    Préparation au test d'inspection/d'entretien
    AVERTISSEMENT Un véhicule Nissan Rogue équipé d’une transmission intégrale ne doit jamais être soumis à un essai sur dynamomètre à deux roues, comme ceux utilisés dans certains États ou provinces pour les tests d’émissions. Assurez-vous que le personnel chargé du test est informé ...

    Writing of Calibration Data
    Work Procedure DESCRIPTIONIf only the around view monitor control unit is replaced, the calibration data stored in the camera can be written to the around view monitor control unit by selecting "Camera Calibration" of "Work Support" mode in CONSULT.WORK PROCEDUREWRITE CALIBRATION DATA With C ...

    Fuel Rail Pressure Sensor
    Component Inspection CHECK FUEL RAIL PRESSURE (FRP) SENSOR With CONSULT Turn ignition switch OFF. Reconnect harness connector disconnected. Start engine and warm it up to normal operating temperature. Select “FUEL PRES SEN V” in “DATA MONITOR” mode of “ENGINE” using ...