Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Intelligent Key System All Functions Cannot Operate (one Key)

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Door & Lock / Symptom Diagnosis :: Intelligent Key System All Functions Cannot Operate (one Key)

Description

Intelligent Key system all functions cannot operate (door lock and engine start). (One Intelligent Key has the symptom, other keys operate normally.)

SYMPTOM TABLE (ONE INTELLIGENT KEY HAS THE SYMPTOM, OTHER KEYS OPERATE NORMALLY)

Door lock operation (remote keyless entry) Door lock operation (request switch of front/rear/back door) or trunk/back door open operation (opener switch of trunk/back door panel) Engine started with push-button ignition switch operation (Intelligent Key is within the detection area of inside key antenna) Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) Unlock operation when approaching the Nissan Ariya vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna)
NG NG No crank, No start No crank, No start NG

DIAGNOSIS PROCEDURE

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE

Check Intelligent Key system symptom table.

Refer to Diagnosis Procedure.

>>

GO TO 2.

CHECK INTELLIGENT KEY-1

For Intelligent Key that cannot be used for door lock and unlock, check that the Intelligent Key belongs to the Nissan Ariya vehicle to be checked.

Does the Intelligent Key belong to the vehicle to be checked?

YES>>

GO TO 3.

NO>>

Check Intelligent Key button operation using a registered Intelligent Key that belongs to the Nissan Ariya vehicle.

CHECK INTELLIGENT KEY-2

Check the inside of the Intelligent Key for rust or corrosion by water. Simultaneously check the internal circuits for damage.

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Replace Intelligent Key.

REGISTER INTELLIGENT KEY

  1. Register the Intelligent Key again.

  2. Check the operation after replacement.

Is the inspection result normal?

YES>>

Inspection End.

NO>>

GO TO 5.

REPLACE INTELLIGENT KEY

  1. Replace the Intelligent Key and perform registration again.

  2. Check operation after replacement.

Is the inspection result normal?

YES>>

Inspection End.

NO>>

GO TO 6.

REPLACE INTELLIGENT KEY UNIT

  1. Replace Intelligent Key unit. Refer to Removal and Installation.

  2. Check operation after replacement.

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Check intermittent incident. Refer to Intermittent Incident.

    Symptom Diagnosis. Door Does Not Lock/unlock and Engine Does Not Start (one I-Key/req Sw/push Sw)
    Description All doors do not lock/unlock using door request switch and engine does not start when push-button ignition switch is pressed while carrying Intelligent Key. (One Int...
    Symptom Diagnosis. Intelligent Key Button Operation Has Poor Range (one Key)
    Description Intelligent Key button operation has poor range. (One Intelligent Key has the symptom, other keys operate normally.)SYMPTOM TABLE (ONE INTELLIGENT KEY HAS THE SYMPTO...

    Other materials:

    Preparation
    Special Service Tools The actual shapes of TechMate tools may differ from those of special service tools illustrated here. Tool number (TechMate No.) Tool name Description (NI-39570) Chassis ear Locates the noise (NI-50397) Squeak and Rattle Kit Repairs the cause o ...

    C1f41-84 Cvt
    Without Propilot Assist 2.1 DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition   C1F41 84 TRANSMISSION CIRCUIT (Transmission circuit) Diagnosis condition When engine is running When AEB system is O ...

    C106e-54 Steering Angle Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C106E 54 Steering angle sensor (Steering angle sensor) Diagnosis condition When ignition switch is ON. When the power supply voltage is normal. ...