Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Engine Can Not Start
Description
Engine does not start when push-button ignition switch is pressed.
SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS)
| Door lock operation (remote keyless entry) | Door lock operation (request switch of front/rear/back door) or trunk/back door open operation (opener switch of trunk/back door panel) | Engine started with push-button ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) | Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) | Unlock operation when approaching the Nissan Ariya vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna) |
|---|---|---|---|---|
| OK | OK | No start | No start | OK |
CONDITIONS OF VEHICLE (OPERATING CONDITIONS)
“ENGINE START BY I-KEY” setting in “WORK SUPPORT” mode of “HANDS FREE MODULE” is ON.
DIAGNOSIS PROCEDURE
Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table. Refer to Diagnosis Procedure.
>>
GO TO 2.
PERFORM SELF-DIAGNOSIS RESULT
Select “Self Diagnostic Result” mode of all systems, and check if DTC is detected.
Is DTC detected?
YES>>Perform the trouble diagnosis for the detected DTC.
NO>>GO TO 3.
CHECK PUSH-BUTTON IGNITION SWITCH
Check push-button ignition switch. Refer to Component Function Check.
Is the inspection result normal?
YES>>Inspection End.
NO>>Check intermittent incident. Refer to Intermittent Incident.
Other materials:
P2238 Ho2s2
DTC Description
To judge malfunctions, the diagnosis checks that the A/F signal
computed by ECM from the A/F sensor 1 signal fluctuates according to
fuel feedback control.DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P2238
00
...
Power Supply and Ground Circuit
Diagnosis Procedure
CHECK CHASSIS CONTROL MODULE ACCESSORY POWER SUPPLY
Ignition switch OFF.
Disconnect the chassis control module harness connector.
Check the voltage between chassis control module harness connector and ground.
+ — Voltage
Chassis control module
Connecto ...
Automatic air conditioner (models without rear control)
Models with heated steering wheel
Models without heated steering wheel
Basic information
Temperature control dial (driver's side)
AUTO button
Display screen
SYNC button
Temperature control dial (passenger's side)
ON·OFF button
Air recirculation button
Fan speed buttons
Air flow ...
